Q: What should my rotors measure at if replacement is needed?

asked by on January 25, 2017

Fronts are 4 mm rears are 6 mm

My car has 106000 miles.
My car has an automatic transmission.

The front rotors minimum thickness is 23 mm and for pads is 2 mm. The rear rotors minimum thickness is 9 mm and pads is 2 mm.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Replaced the transmission and now car won't start
I highly doubt the powertrain control module (PCM) (also known as the ECU (https://www.yourmechanic.com/article/what-is-a-vehicle-s-electrical-control-unit)) is bad. Code P025A indicates a problem with a faulty fuel pump (https://www.yourmechanic.com/services/fuel-pump-replacement) or its circuit, which could definitely be causing the problems you are having....
broken timing belt
Replacing the timing belt is not a job to take lightly. If you have never done one before, I suggest you get a shop manual. If your belt broke while you were driving, you probable bent valves in the head....
I have a loose battery terminal
If the terminals are loose then try and tighten them. If they will not tighten up to the battery then the best way to fix them is to replace the entire cable assembly. If a less expensive repair is needed...
If a mechanic put one of the fuel injectors in the wrong cylinder, could this damage the ECU?
Hello. The ECU could not have been damaged by moving injectors to different cylinders. The injectors are not programmed to be in a particular cylinder of the engine. Having only two injectors reconditioned is the most likely cause for running...
The cam chain snapped. Is the engine on a 2011 Ford Transit 2.4L a non-interference engine?
Hello and thank you for contacting Your Mechanic. The engine in your ford 2011 is a tdci diesel 2.4 engine. The engine is an interference engine and the valve train could be damaged. Install the new chain on the camshaft...
I have replaced a failed alternator once a month for the last four months, any suggestions?
Your vehicle has a recall for the alternator cable shorting on the power steering line after the insulation gets rubbed through. The recall is for inspecting and replacing the alternator and alternator wiring. The recommendation I have is to contact...
Clunking noise from the center column when turning right and accelerating out of the turn
You're right, the center support shouldn't respond only to right turns, but that doesn't mean it shouldn't be checked. Your car is old enough to be having issues with the driveshaft as well as the rear sub-frame mounts, differential mount...
how do wagner brake rotors and pads compae to stock GM
Hi Jerry. Thanks for writing in today. I am a fan of this brand of brake system components. However, in regards to being "better" than OEM, that's a very difficult question to provide a straight and clear answer. Generally speaking,...

Related articles

A Buyer’s Guide to the 2012 Honda Odyssey
Minivans Minivans may not be the sportiest, sleekest, or sexiest vehicles on the road, and people in the market for a vehicle to haul all of their kids, pets, and gear around may not be too preoccupied with how that...
A Buyer’s Guide to the 2012 Audi R8
The The 2012 Audi R8 is a two-door sports car with plenty of power and performance to offer. It manages to combine an aggressive stance and plenty of get-up-and-go with the comfort and interior refinement you’d expect from a German...
Mazda Certified Pre-Owned (CPO) Car Program
If If you have been shopping for a used Mazda vehicle, you may want to check out cars under their certified pre-owned program. Many manufacturers have a certified pre-owned (CPO) program, and each one is set up differently. Read on...