I want to khow detail about codes showing in my car scann...
Customer
I want to khow detail about codes showing in my car scanning
2014 mazda 6
...
I want to khow detail about codes showing in my car scanning
2014 mazda 6
Read More
Responses
DannyR924
232 days ago
Automotive Expert
Hello again is me Danny, give me a few while I look it up.
DannyR924
232 days ago
Automotive Expert
The first two first codes, means that you either got a vacuum leak or the mass air flow is dirty or need replacing. Check your air filter, clean and replace if needed. Check the mass air flow sensor if is dirty also.
Customer
232 days ago
third one ?
DannyR924
232 days ago
Automotive Expert
This last code triggers a lot when people drive with two feet, reset the computer and see if it comes back on, try no to press the accelerator and brakes at the same tiem.
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
The Brake light on the dash of your car is designed to provide you with important information about the brake system and its condition. Here’s what you should know: The Brake light should come on briefly during engine startup. It...
If you have went as far to do compression and leak down, I’ll assume the problem is not obvious. After those tests, you can be almost sure the mechanical components of the engine are good. Is it a random misfire...
Hi. If the engine will turn over and try to start, then it may be a problem with fuel pressure or one of the engine sensors. It is common for the fuel pump to fail as well as the crank...
Hello. I usually start by checking the computer for codes. I also use the scan tool to see what the sensor are reading. Most of the time this is caused by an airflow sensor that is not reading right or...
You have a leak. The only question is where. YourMechanic will pressurize the cooling system when COLD which should reveal the leak without too much trouble. A common leak would be through the water pump bearing weep hole, especially if...
Hi there. There are several possibilities here before replacing the motor may be required. Check the 40 amp fuses for the motor first, and also check the relay for the lift motor as well for burned contacts. The fluid level...
Check all the ignition system primary circuit electrical connections to the distributor and test the coil and the distributor. Be sure all electrical connections were restored and are secure. It is possible that an electrical connector was just left disconnected,...
Hello, thank you for writing in. Having the two front tires is typically priority for a couple of reasons. One being the front tires support the engine and transmission, meaning they hold a majority of the weight. The vehicle is...
Working with starting fluid can be pretty dangerous. One backfire and you can lose your eyebrows in a flash...or worse. That said: a car that is hard to start when cold could just have an air leak. Look for any...
I want to khow detail about codes showing in my car scanning 2014 mazda 6 ...
I want to khow detail about codes showing in my car scanning 2014 mazda 6