Look for degree for cam synchronizer at tdc 2001 Ford [Ta...


Look for degree for cam synchronizer at tdc 2001 Ford [Taurus](/topics-taurus/) 3.0 ses ohv Mechanic's Assistant: Okay, I'll connect you to the Mechanic to discuss this further with you. Before I do, is there anything else...

Look for degree for cam synchronizer at tdc 2001 Ford [Taurus](/topics-taurus/) 3.0 ses ohv Mechanic's Assistant: Okay, I'll connect you to the Mechanic to discuss this further with you. Before I do, is there anything else you want him to know? No sir

Automotive Expert
Greetings. I work here helping customers like you repair their vehicle. Let’s begin with a diagnosis, plan and repair that will save you money. What is your question again?

Great
Automotive Expert
See if this section answers your question,

this helped
Automotive Expert
Great!

What others are asking

What does the Low Battery message mean?
The Low Battery message can appear on your driver information center (DIC). When the DIC displays this alert, that means that your battery is running low.
Car not stopping when I press brake pedal.
I believe you may have a problem with your master cylinder. I would suggest first having the brake fluid flushed if it is dark. If that doesn't fix it then most likely the master cylinder is bad. I would have...
Car hesitating while driving
If your vehicle has a Check Engine light, I would recommend starting there. Any trouble codes found in the system would likely be related to your issue, and would aid in diagnosis of this issue. Some possible causes of your...
Dash lights wont turn off.
It sounds like you may have an internal short within your light switch assembly caused by water intrusion. Having your dash lights on all night is what killed your battery (https://www.yourmechanic.com/services/battery-is-dead-inspection). A certified technician, like one from YourMechanic, will be...
Grinding/Loose part front right tire RAV 4, Whats the issue?
This may suggest you have wheel bearings going out. A wheel bearing will usually fail due to pitting or small damage on the surface of the rollers or the bearing race. Both the surface of the rollers and the race...
car overheated.fixed cylinderhead gasket replaced sparks n wires cant get it running
Hello, thank you for writing in. When the engine overheats to a certain point, there is damage done to the engine that is irreversible. The biggest concern is that inside of the engine, the pistons can heat up to the...
I changed the throttle body on my Murano and ever since gas pedal is unresponsive? I did all 3 relearn procedures. What is wrong? 2004 Nissan Murano
Hello - there are a couple of possibilities for the "failure to relearn" of the new throttle position sensor (https://www.yourmechanic.com/article/how-to-replace-a-throttle-position-sensor-by-mia-bevacqua)". If engine management recognizes an invalid parameter during the relearn process (low system voltage, AC compressor kicking on, etc.), it...
Fuel gauge still reading as full after driving
Hello. There are not many things which can cause an erratic fuel gauge reading. They're usually one of two things, the fuel gauge display itself as being faulty or a bad fuel gauge sending unit. I suggest that you drive...
car will turnover but wont start.
Hello, and thank you for writing in. The vehicle is likely experiencing some issues with control module that communicated between the anti-theft components. Typically when the vehicle is messed with and the anti-theft system goes into action, you will need...