Mercedes-Benz GLE350 Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(30)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(30)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz GLE350 Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2020 Mercedes-Benz GLE350L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2017 Mercedes-Benz GLE350V6-3.5LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2016 Mercedes-Benz GLE350V6-3.5LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2021 Mercedes-Benz GLE350L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2018 Mercedes-Benz GLE350V6-3.5LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2022 Mercedes-Benz GLE350L4-2.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Mercedes-Benz GLE350 Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(30)

Rating Summary
29
0
0
1
0
29
0
0
1
0

Shawn

23 years of experience
187 reviews
Shawn
23 years of experience
Mercedes-Benz GLE350 V6-3.5L - Brake Pads Replacement (Front) - Newport News, Virginia
Great service and Shawn finished the job in no time.

Behrak

9 years of experience
339 reviews
Behrak
9 years of experience
Mercedes-Benz GLE350 V6-3.5L - Headlight Bulb Replacement (Driver Side Low Beam, Passenger Side Low Beam, Driver Side High Beam, Passenger Side High Beam) - Roswell, Georgia
Behrak was ontime and very efficiently took care of business. Very pleasant and competent.

Eduardo

19 years of experience
555 reviews
Eduardo
19 years of experience
Mercedes-Benz GLE350 V6-3.5L - Brake System Flush - Richmond, Texas
Eduardo did an excellent job! Will use his services again.

Desmond

20 years of experience
51 reviews
Desmond
20 years of experience
Mercedes-Benz GLE350 V6-3.5L - Oil Change - Pebble Beach, California
Desmond was great to work with. He completed the repairs ahead of schedule and was friendly in explaining the work that had been performed.

Excellent Rating

(30)

Rating Summary
29
0
0
1
0
29
0
0
1
0
Number of Mercedes-Benz GLE350 services completed
330+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

P2274 OBD-II Trouble Code: O2 (Oxygen) Sensor Signal Stuck Lean Bank 1 Sensor 3
P2274 P2274 code definition O2 (Oxygen) Sensor Signal Stuck Lean Bank 1 Sensor 3 What the P2274 code means This code definition indicates that either the oxygen sensor has failed, there is an exhaust leak before the sensor, or the...
How to Replace a Washer Fluid Level Switch
The washer fluid level switch fails when the Windshield Fluid Warning Light stays illuminated or there are unusual noises coming from the washer pump.
How to Save on Car Insurance With a Defensive Driving Discount
Defensive driving classes can reduce your car insurance rate and teach you essential driving skills like how to handle skids and use anti-lock brakes.

Long stall between 2nd and 3rd gears, plus whining noise

Hello Without having a good impression of the actual symptoms you are experiencing, it would be difficult to tell you the exact problem. I would recommend having your transmission fluid level and condition checked first. Then, if the fluid level...

Car keeps needing to be jump started after sitting for a day or two

Pep boys is probably right about there being a drain, but they may not have the know-how or equipment to detect it. Chances are your CAN (control area network) is not 'going to sleep." The can is the line of...

Manual gear shift hard to move

This may suggest the transmission synchros may be wearing out. Your transmission has small gear synchronizer rings that help to move the transmission in and out of the various gears. When these begin to wear out, you may notice it...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com