Kia Sephia Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(49)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(49)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Kia Sephia Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1995 Kia SephiaL4-1.6LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2000 Kia SephiaL4-1.8LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1996 Kia SephiaL4-1.8LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1996 Kia SephiaL4-1.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1997 Kia SephiaL4-1.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1994 Kia SephiaL4-1.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1998 Kia SephiaL4-1.8LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1999 Kia SephiaL4-1.8LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Kia Sephia Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Kia mechanics

Real customer reviews from Kia owners like you.

Excellent Rating

(49)

Rating Summary
46
1
0
0
2
46
1
0
0
2

Richard

21 years of experience
461 reviews
Richard
21 years of experience
Kia Sephia L4-1.8L - Car is not shifting into park - Atlanta, Georgia
Richard knows his stuff! Sincere, competent and diligent!

Jose

17 years of experience
433 reviews
Jose
17 years of experience
Kia Sephia L4-1.8L - Serpentine/Drive Belt - Vancouver, Washington

Edgar

8 years of experience
202 reviews
Edgar
8 years of experience
Kia Sephia L4-1.8L - Serpentine/Drive Belt - Austin, Texas
Another great experience with Edgar. He replaced my power steering pump & my serpentine belt in a timely manner in this triple digit heat. Thank you! As always he had a smile and friendly disposition and I will be contacting Edgar again soon for some more maintaince on my car. Thank you again Edgar, keep being awesome and rockin n Rollin. 落

Dave

23 years of experience
303 reviews
Dave
23 years of experience
Kia Sephia L4-1.8L - Serpentine/Drive Belt - San Jose, California
He showed up on time, (a big plus) and completed the job, in the allotted time. All in all, a perfect experience.

Excellent Rating

(49)

Rating Summary
46
1
0
0
2
46
1
0
0
2
Number of Kia Sephia services completed
539+
services done by our mechanics
TOTAL NUMBER OF EXPERT Kia MECHANICS
1000+
experts on our platform

Recent articles & questions

How to Top Up the Oil in Your Car
Regular car maintenance can make a huge difference with keeping your vehicle in good condition. For major repairs and special jobs,...
P2529 OBD-II Trouble Code: Vacuum Reservoir Press Sensor Circuit Intermmittent
P2529 code means the vacuum reservoir pressure sensor is not sending an input signal due to a defective vacuum sensor, pump, hose, valve, or a leak.
How to Replace an Anti-Lock Brake Fluid Level Sensor on Most Modern Cars
The anti-lock brake (ABS) system has a fluid level sensor that fails when the warning light comes on or if there is low fluid in the reservoir.

Engine runs fine but no power to the wheels when the car is in drive or reverse.

The first thing to do is to have the computer and transmission scanned to get the codes stored. Depending on the codes stored the transmission may have a bad pressure control valve that is not letting it move. A full...

My car makes a chirping noise while in motion, the noise is more frequent based on how fast I'm traveling.

You should have the brake sensors checked to see if the brakes are worn to the sensor or the backing vent plate is rubbing the rotor. If both are good then you may have a front wheel bearing then is...

I have the 4 error codes . And I looked them up in the diagnostic book. I was told by a phone representative to ask you

Unfortunately, without the error code numbers this would be difficult to interpret. Please feel free to send us the specific error codes and we will be glad to help you.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com