Chevrolet Impala Limited Power Steering Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(21)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(21)

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Chevrolet Impala Limited Power Steering Pump Replacement is $407 with $183 for parts and $224 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2014 Chevrolet Impala LimitedV6-3.6LService typePower Steering Pump ReplacementEstimate$614.32Shop/Dealer Price$711.66 - $990.72
2016 Chevrolet Impala LimitedV6-3.6LService typePower Steering Pump ReplacementEstimate$755.16Shop/Dealer Price$888.49 - $1281.88
2015 Chevrolet Impala LimitedV6-3.6LService typePower Steering Pump ReplacementEstimate$755.16Shop/Dealer Price$888.53 - $1281.95
Show example Chevrolet Impala Limited Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

  • Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
  • Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
  • Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
  • Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

  • If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
  • If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
  • The threaded connectors to the pump inlet and outlet are loosened and removed.
  • Any mounting bolts and brackets are removed so the pump can be removed.
  • If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
  • The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
  • Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

  • Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
  • Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(21)

Rating Summary
20
1
0
0
0
20
1
0
0
0

Jose

6 years of experience
63 reviews
Jose
6 years of experience
Impala Limited 2016 - Spark Plugs - Palo Alto, CA
My man was prompt and was done in a timely manner.

Stacy

20 years of experience
330 reviews
Stacy
20 years of experience
Impala Limited 2014 - Brake Pads - Morrow, GA
Stacy showed up on time and was very professional

Bryant

8 years of experience
568 reviews
Bryant
8 years of experience
Impala Limited 2016 - Brake Rotor/Disc - Indianapolis, IN
While I was bummed that my rotors were involved as well, Bryant busted the whole job in no time flat. I am quite happy with how everything turned out! Thank you!

John

30 years of experience
444 reviews
John
30 years of experience
Impala Limited 2014 - Wheel Bearings - Richmond, CA
Great guy would consult with him again.

Excellent Rating

(21)

Rating Summary
20
1
0
0
0
20
1
0
0
0
Number of Chevrolet Impala Limited services completed
231+
services done by our mechanics
TOTAL NUMBER OF EXPERT Chevrolet MECHANICS
1700+
experts on our platform

Recent articles & questions

How to Replace an Evaporation Vent Solenoid
Emissions are regulated in part by the EVAP vent solenoid which goes bad when your car fails emissions testing or has extra pressure in the gas tank.
P0483 OBD-II Trouble Code: Cooling Fan Rationality Check Malfunction
P0483 code means that the cooling fan has been commanded to turn on or off, but the voltage reading indicates that the fan did not respond.
P3492 OBD-II Trouble Code: Cylinder 12 Deactivation/Intake Valve Malfunction
P3492 P3492 code definition P3492 is the fault code for what’s known as Cyl12 Deactivation/Intake Valve Ctrl Circ High. Cyl12 specifies that the issue is likely taking place in engine cylinder number 12. In some Dodge vehicles, this code indicates...

My engine is overheating.

Hi there. Check the condition of the coolant and see if its full and new. I recommend putting a new radiator cap on and putting in a new thermostat. Once a thermostat is introduced to the atmosphere after being submerged...

My horn and brake lights are not working

My truck keeps smoking after short trips for some apparent reason

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com