Acura Legend Car Battery Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(45)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(45)

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Acura Legend Car Battery Replacement is $289 with $149 for parts and $140 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1993 Acura LegendV6-3.2LService typeCar Battery ReplacementEstimate$452.04Shop/Dealer Price$532.60 - $760.11
1995 Acura LegendV6-3.2LService typeCar Battery ReplacementEstimate$443.03Shop/Dealer Price$520.50 - $745.69
1991 Acura LegendV6-3.2LService typeCar Battery ReplacementEstimate$443.03Shop/Dealer Price$520.54 - $745.76
1992 Acura LegendV6-3.2LService typeCar Battery ReplacementEstimate$443.03Shop/Dealer Price$520.54 - $745.76
1990 Acura LegendV6-2.7LService typeCar Battery ReplacementEstimate$453.79Shop/Dealer Price$536.57 - $771.79
1994 Acura LegendV6-3.2LService typeCar Battery ReplacementEstimate$443.03Shop/Dealer Price$520.79 - $746.19
Show example Acura Legend Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

  • Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
  • Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
  • Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

  • A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
  • The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
  • Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
  • The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
  • Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
  • The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

  • The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
  • Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
  • Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
  • Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Acura mechanics

Real customer reviews from Acura owners like you.

Excellent Rating

(45)

Rating Summary
41
2
1
0
1
41
2
1
0
1

Trevor

24 years of experience
11 reviews
Trevor
24 years of experience
Acura Legend V6-3.2L - Battery - San Jose, California
Trevor arrived at my home on time. Wow, I've never had anyone arrive on time for anything. He found the problem, and explained in detailed what he would need to do to solve the problem. He went and picked up the part, and the car is now fully operational. Also, it was not as expensive as I thought it would be. Oh yeah, I also saved on towing cost.

Gerron

35 years of experience
185 reviews
Gerron
35 years of experience
Acura Legend V6-3.2L - Fuel Pump - Portland, Oregon
Very friendly and shows up on time Competent and extremely knowledgeable

Trung

13 years of experience
412 reviews
Trung
13 years of experience
Acura Legend V6-3.2L - Brake Pads Replacement (Rear) - Union City, California

Robert

32 years of experience
646 reviews
Robert
32 years of experience
Acura Legend V6-2.7L - Starter - Portola Valley, California

Excellent Rating

(45)

Rating Summary
41
2
1
0
1
41
2
1
0
1
Number of Acura Legend services completed
495+
services done by our mechanics
TOTAL NUMBER OF EXPERT Acura MECHANICS
1000+
experts on our platform

Recent articles & questions

Understanding the Dodge Oil Change Indicator and Service Indicator Lights
Car symbols, or dashboard lights, are a car service reminder. The Dodge Oil Change Indicator lets you know when and what service your car needs.
P0798 OBD-II Trouble Code: Pressure Control Solenoid “C” Electrical
P0798 means there is a problem with the electronic pressure control solenoid or solenoid circuit due to low or dirty transmission fluid.
P3441 OBD-II Trouble Code: Cylinder 6 Deactivation/Intake Valve Control Circuit/Open
P3441 means the PCM doesn’t receive the correct information from the MAF, MAP, and TP sensors due to clogged oil, low oil pressure, or shorts.

Advice on buying a Rav4

Out of those options, I'd say buy the '04 RAV4 (https://www.yourmechanic.com/scheduled-maintenance/toyota-rav4/?year=2004&mileage=100000). The earlier ones had some problems with the oxygen sensors (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-oxygen-sensor) and catalytic converters (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-catalytic-converter). The '04's really didn't. I'd say get yourself an '04. They are really well...

Just had timing chain replaced on 2012 qx56 and they called" -- dealer called and said while fixing the timing belt that my ac pum

Hi there. It does seem kind of suspicious that your vehicle went in with ac and now it doesn't work. I completely understand how you feel and hope to help you fix this. However, component failure can happen at any...

2013 Ford Fusion Car won't start and has a clicking noise when I turn the key... what's wrong

It sounds like you may have a weak battery, a failing voltage regulator or failing alternator. The rapid clicking sound is the starter trying to engage the flywheel to turn the motor over. When the battery is too weak to...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com