Q: Where is the crankshaft position sensor location

asked by on September 19, 2016

Removal of crankshaft position sensor

My car has 124000 miles.
My car has an automatic transmission.

Crankshaft Position Sensor Replacement $120.83 - $900.50 Get a Quote

Hey there, thanks for writing in. The sensor is on the right rear of the engine block behind the exhaust manifold heat shield. If you need help replacing the crankshaft position sensor, a certified technician from YourMechanic can come to your car’s location to perform this job.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

What does the Low Oil Pressure light mean?
The Low Oil Pressure light on your dash looks like a small oil can, and it should light up under very specific circumstances. Here’s what you need to know: The light should come on briefly when you crank the engine....
When accelerating, car shakes
I believe what you are experiencing is a misfire condition. Basically, this is when one or more of the cylinders in your engine stop producing power due to a lack of fuel spark, or oxygen, that is necessary for combustion....
My car has low oil pressure. I've already changed the oil pressure sensor 3 times.
If you have replaced the sensor three times and it did not fix the problem, then you may have problems with the oil pressure being low at idle due to wear in the engine bearings. The reason it would be...
Erratic Idle
Hello! It sounds like you may have a dirty or faulty idle air control valve. The idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) monitors the air intake as it is mixed with fuel prior to being injected into the engine at low...
Rough Starts & Idle
The fuel pump code for the secondary fuel circuit fault may be the fuel pump module on the cross member under the truck. The module can go bad and cause no fuel pump operation intermittently. The engine vacuum line from...
I have a 2015 Ford F-150 2800 miles on it. Transfer case output shaft seal started leaking. Dealer covered it under factory warra
This can happen due to a few reasons. It's possible there was a manufacturing issue/defect with the seals. They could have not only gotten into the production line, but the parts supply network as well. Another issue can be the...
Car doesn't go straight yet, no mechanical failure can be found
The vehicle is not properly aligned. Prior to performing an alignment be sure the suspension fully checks out and is not worn. Also, if you have any suspicion of frame damage that should be evaluated at the time of the...
24 or 50 oz imbalance in a ford 302 with a 1980 block and harmonic bal #E1TE-B4aA ?
The balancer number you provided is from model year 1981 and thus is a 50 ounce balancer. The only way to determine the model year of the crankshaft, and thus whether the current 50 ounce balancer is the correct one...
Iac valve
When you turned on the key the IAC was energized and would push out the spring due to this. Just put spring back in and reinstall after it is cleaned.

Related articles

3 Essential Things to Know About Your Car’s Tachometer
The The tachometer is located on the dashboard next to the speedometer. It measures the revolutions per minutes (RPM). The tachometer can be a digital display or on a calibrated analogue dial. They are on both automatic and manual vehicles....
The Best Used Cars to Buy If You Live in a City
Living Living and driving in the city means you’re faced with parking constraints, narrow streets, and the constant stop and go of traffic. With all of that said when you’re ready to purchase a used vehicle these are all things...
How Long Does a Mass Airflow Sensor Last?
The The right amount of air and fuel in your engine is a vital component in keeping the engine running as it should. Making sure that all of the vital components of the air and fuel system are running at...