I have a 2011 Volkswagen CC it starts but it turns over r...


I have a 2011 Volkswagen CC it starts but it turns over really slow Mechanic's Assistant: Will the headlights turn on? Is the battery fully charged? All lights turn on Mechanic's Assistant: What is the model of yo...

I have a 2011 Volkswagen CC it starts but it turns over really slow Mechanic's Assistant: Will the headlights turn on? Is the battery fully charged? All lights turn on Mechanic's Assistant: What is the model of your '11 VW? CC Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far? I haven’t tried anything I was thinking a new battery


Ok
Automotive Expert
Hello I'm Wolfgang . Let us see if we can get you going. Have you tried to jump start the vehicle to see if the cranking speed goes faster?

No I just bought the vehicle yesterdayI was thinking buy a new battery
Automotive Expert
Here is a deal if you can get the car running head out to either Auto zone or Advanced auto parts and they can test the battery . It could be just that but a test of the battery would be the best thing .

Ok thank you
Automotive Expert
My pleasure!!
Automotive Expert
please do rate my service to you on your page!! Stay safe!!

What others are asking

How Does the Anti-Pinch Feature Work on My Power Windows?
Basically, anti-pinch works by measuring the amount of electrical current the motor uses that drives the glass up and down. Like practically everything on a modern car, the windows are controlled by an electronic control unit (ECU) (https://www.yourmechanic.com/article/how-your-ecu-uses-sensor-data). When you...
Knocking noise from front tire
It would be helpful to know why were the components you mentioned were replaced in the first place. There are a few more components in the front end that could cause this issue. Problems with the sway bar links are...
Won't start
A number of faults can occur when an engine overheats. If the engine was overheated severely, it is possible that the engine has internal damage and has seized. Also, engine electronics are very sensitive to heat and liquids. If coolant...
Rear brake clicking noise after putting on a set of shoes and drums.
Hi there. Check the hardware to the shoes and see if the springs are sprung. A loose brake return spring will cause a clicking sound as its touching the drum when the brakes are applied. If the springs are the...
Engine light on code reads gas too lean what does that mean
Hi There, When the engine is running too lean this means that there is not enough fuel getting to the combustion chamber to be ignited as the engine runs. This can cause many different problems such as the engine stalling...
The heat in my car started blowing cold then car ran hot then cut off now it won't turn over
The heater may have started to go cold due to the engine getting low on coolant and from the overheating. The engine may now not turn over due to overheating until the engine stopped seized the motor and coolant may...
Rattling noise under the hood, VDC and slip light both on 2010 Nissan Altima
Hi there - the Vehicle Dynamics Control (VDC (https://www.yourmechanic.com/question/what-does-the-vehicle-dynamic-control-vdc-warning-light-mean)) system uses the anti-skid brake system (ABS) and engine throttle control to enhance vehicle stability in extreme conditions - like cornering while it’s raining. Most often, problems with this system are...
Long cranking
There are many causes of hard starting but illustrative ones are a faulty engine coolant temperature switch (sensor), worn spark plugs, inadequate fuel delivery or pressure (caused by other than fuel filter in your case), and contaminated or old gasoline....
Engine code, left bank overretard and engine shaking 2004 Ford F150
Hi there - there are several possible cause for over-retarded cam timing (https://www.yourmechanic.com/article/p0012-obd-ii-trouble-code-camshaft-position-a-timing-over-retarded-bank-1-by-jay-safford). The VCT solenoid could cause this, but a failed cam phaser, worn timing chain guide, stretched timing chain or simply low oil pressure can also cause this...