My pump doesn’t engage when I press for the screenwash to...
Responses
ENES
274 days ago
mostly go mechanic tell him to replace washer pump he must raise car and replace the washer pump that goes inside washer fluid tank they do go bac frequently
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
How do I fast forward and rewind an iPod?
While listening to your iPod through the sound system, you can fast forward and rewind through songs. To fast forward through a track, press and hold the Seek button for more than 0.8 seconds. To rewind through a track, press...
Car misfires
Hi there. Though misfires can be caused by a number of reasons, a misfire that is present only when the vehicle is first started only has a few common causes. Most of the time this is caused by oil or...
Why wont my car start?
You should try testing the battery (https://www.yourmechanic.com/article/how-to-check-a-car-battery)first. Verify it's good and at least 75% charged. Because your car has a PassKey theft deterrent system, a faulty ignition lock cylinder (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-ignition-lock-cylinder) can cause this on your '95 Monte Carlo. There should...
Do I need new brakes or rotors or both?
Hi there. Without knowing the specifics about your vehicle, such as make, model, year, or being onsite to physically complete a brake inspection, it is very difficult to tell you how much work will be required. However, if your brakes...
Ignition coil
Hi, thanks for writing in. Your engine has six coils, one per cylinder. The connector should be squeezed then pull off the coil. Hope this helps and best of luck.
How much would it cost to put a 6.1 or 6.4 hemi in my truck? 2001 RAM 1500
Hi there - unfortunately, this is not a service YourMechanic can offer at this time. Thanks for thinking of us however!
My car only accelerates directly after I start it. After a short period, it stops responding to the gas pedal being pressed.
You will need to have the computer scanned and the fuel pressure tested to see if the pressure is low. Since there is a problem then the system tests will identify the cause of the loss of power. You either...
Stalling issues 02 passat. Fuel pump and fuel pump relay
Causes of stalling include a faulty mass airflow sensor, faulty camshaft or crankshaft position sensors, worn spark plugs, wires or defective ignition coil(s), inadequate fuel delivery or pressure (clogged fuel filter, injectors, faulty fuel pump or pump circuit), contaminated or...
Push the gas pedal and the car moves slowly until it finally catches up. The engine sounds funny. How much to get it looked at?
What your car is experiencing is referred to as "loss of power". Among common possibilities for loss of power are throttle body faults (electronic throttle controls, mass airflow sensor, torn air intake hose), worn out spark plugs, faulty fuel pump...
Browse other content
Maintenance
Cities
My pump doesn’t engage when I press for the screenwash to come through the jets. All of my wipers work however, when the button is pressed, no wash comes through the jets and there is no noise either Mechanic's Assistant: ...
My pump doesn’t engage when I press for the screenwash to come through the jets. All of my wipers work however, when the button is pressed, no wash comes through the jets and there is no noise either Mechanic's Assistant: Have you checked the fuses? Do you know if there is power to the wiper motor? I don't know how to check the fuses or which one it would be. How would I know if there is power to the wiper motor? All my wipers work and my rear wiper also works when I pull back for screenwash at the rear. I just have no screenwash coming out Mechanic's Assistant: What is the make/model/year of your car? It is a 2015 Ford Ecosport Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far? I will try and either fix myself/ask my dad to help. At first I thought it was just that the jets were frozen over but that doesn't seem the case. It was working fine and has stopped suddenly Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? That's it, thank you