Q: How do I fast forward and rewind an iPod?

The other Warning Light is located on your instrument panel. This light illuminates as a reminder to check or service vehicle items that don’t have their own service lights. The other Warning Light is programmed to come on after a...

If your car is not turning off, and you are unable to remove the key, that may be sign that the ignition lock, or possibly switch, has gone bad. A failed ignition lock or switch can sometimes fail, and jam...

Hello there. It sounds like something weird happened when you connected the new sensor and rewired it. From what you have described, there may a a short somewhere in the system that is causing the AC system to act up,...

If you have replaced all of those components and you're still getting issues then the problem should be in the fuse box (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-fuse-box) with the body control module fuse located in it (on the driver side) or there is an...

When you ran the fuel pump dry of fuel, the fuel pump may have seized up. Fuel pumps use the fuel in the tank to keep it cool so it does not overheat and also lubricates the internal parts as...

Hello - usually power to the ignition switch (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-ignition-switch), engine swap or not, comes through the fuse block. So, first thing to check is the appropriate fuse for the ignition from the Jeep Owners Manual. With the engine swap, unless...

There are several possible causes for a vehicle to crank and not start (https://www.yourmechanic.com/services/car-is-not-starting-inspection). There could be a bad fuel pump, faulty plugs, bad timing belt/chain, faulty ignition, failed camshaft/crankshaft sensor, or any number of other possible causes. It would...

The flasher is in the under dash fuse/relay box. If you need assistance testing the unit and/or pinpointing the cause of a problem with the turn signals, please request turn signal/flasher circuit diagnostic/replacement (https://www.yourmechanic.com/services/hazard-turn-signal-flasher-replacement) and the responding certified mechanic will...

Diagnosing this issue requires the Factory Service Manual and the wiring diagram at minimum. If the turn signal circuit is not working when the vehicle is on, and it is wired through this DCM, that circuit is simple enough that...