Thank you I will get my mechanic to perform a battery and...


Thank you I will get my mechanic to perform a battery and alternator test ...

Thank you I will get my mechanic to perform a battery and alternator test

Automotive Expert
Your very welcome, if you have any questions while the vehicle is in just let me know, thanks!

What others are asking

Tire pressure system malfunctioning.
The tire pressure monitoring system may need to be placed in a relearn mode in order to relearn the tire pressure from each of the tires. As the relearn procedure is being completed the car signals as it reads from...
AC blower going out?
The clogged line caused the evaporator case to flood out. The problem is the blower motor and the blower motor control resistor may of got flooded out with the water and caused them to short out. If you can get...
Shaking while braking
Hello. I’ve had experience with new rotors being warped right out of the box. There is a limited warranty on the rotors from the store. If you can return them and get new front rotors or get them turned, that...
What is causing this stalling problem - 1987 Chevrolet Nova
This is a problem that in most modern cars is now solved with an idle air control module which regulates how the fuel and air is mixed at idle or when coming down to an idle from higher RPM's. In...
No bus
Hello and thank you for contacting YourMechanic. First check all of the fuses on the fuse box in the cab for any of them that could be blown out. Sometimes fuses can pop when hooking up a fully charged battery...
Car is not starting and overheating
Hi there. Usually if the engine starts to overheat it won't damage your cylinder heads unless excessive overheating has occurred. However, if the engine overheated, coolant that may have spilled over may have caused an ignition system issue that's preventing...
What type of ATF for ford fusion se 2009
Hi Sam. For the 2009 Ford Fusion, you'll want to use a Motorcraft Genuine Ford Fluid XT-10-QLVC MERCON-LV Automatic Transmission Fluid. You should purchase a service and repair manual for your Fusion for specific instructions on how to complete this...
Hood won’t close all the way
Hey Caleb. Thanks for contacting us today. Since this is likely an aftermarket hood, and we are not able to offer tips for anything beyond OEM applications, I think your best bet is to contact the manufacturer of the hood...
is it the waterpump going out or gone out
Hi Linda. Thanks for contacting us tonight. Typically, water leaking from the water pump location is an indication of damaged inner seals, which means the pump is damaged. It's recommended to replace the water pump when this happens.