Hi, how many engine temperature sensor on 2008 nissan not...


Hi, how many engine temperature sensor on 2008 nissan note? Mechanic's Assistant: Okay, I'll connect you to the Mechanic to go over that information regarding your Nissan. Before I do, is there anything else you want him t...

Hi, how many engine temperature sensor on 2008 nissan note? Mechanic's Assistant: Okay, I'll connect you to the Mechanic to go over that information regarding your Nissan. Before I do, is there anything else you want him to know? Great

Automotive Expert
"Hi, I'm Roy. Welcome to JustAnswer. I'm reviewing your question now, and will post back with your reply momentarily." You will see an option to receive a phone call prompted by the website, you can agree to or decline. If you do not wish to use the Phone Service, we can continue chatting this way back and forth until you are satisfied with my help. Who Am I speaking with today ?

Hi Roy
Automotive Expert
Hi! Hope I can help sorry to hear about your sensors , here are the engine sensors
Automotive Expert
sensors

I'm trying to find a [coolant](/topics-coolant-nissan/) temp sensor for Nissan Note 2008 model that has an HR15 engine on itIs it the same one as a temperature gauge sensor or a different one?
Automotive Expert
you have a small one for the gage and a square one for the ECM signal

Any picture of the square one?Location of where its mounted
Automotive Expert
should be on the intake back side
Automotive Expert
Some are on the thermostat housing also
Automotive Expert
Post back if you have any questions, Thank you Roy!

What others are asking

Acceleration problems in 2004 Toyota Solara
Your particular vehicle has an electronic throttle body that drives by wire, rather than a mechanical cable. The electronic throttle body relies on signals from the accelerator pedal to know how much to open or close the throttle plate. A...
2003 Ford explorer.i put it in reverse and pressed the gas and it wouldn't move
The transmissions on the Explorers had issues with the reverse and drive band servo binding in the shaft hole on the transmission case. The transmission case would need to be modified by inserting an over-sized bushing in the case, or...
Cooling
Fill the reservoir with water and look to see where it is leaking from. The reservoir is an easy item to replace if that's what is leaking. You may also need to open the radiator cap to properly fill the...
Turning loud bang noise
Hey there. There are a lot of potential causes for this noise. You could have one or multiple issues ranging from: bad outer CV joints (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement), binding tie rod ends (https://www.yourmechanic.com/services/tie-rod-end-replacement) or ball joints (https://www.yourmechanic.com/services/ball-joint-front-replacement), a bad strut bearing plate...
Starting disabled service throttle. That's all it says, it wont start, what do I do ?
From what you've described, it sounds like you have a problem with your electronic throttle control system. Make sure your battery (https://www.yourmechanic.com/services/service-battery-cables) is good, if it is you may need to replace your throttle control valve to fix this issue...
Key turns in ignition tumbler but it gets stuck in the on position and won't start.
Hi there. It is possible that the key lock in the steering column may have broke. This lock is what returns the ignition tumbler back to the rest OFF position. The lock may have broke making the key not move...
What is the standard thickness of front break pads on a 2013 toyota corolla?
The standard thickness of just about all new brake pads is around 10mm. If your brake pads are at 5mm, they have about half of their usable life left. I would recommend replacing your brake pads when they reach a...
emergency brake broke
If the cable has broken, to obtain a repair quote, please click on "Get a Quote" at YourMechanic's emergency brake cable replacement service page (https://www.yourmechanic.com/services/emergency-parking-brake-cable-replacement). As long as the parking break lever is not damaged and the remainder of the...
Is it possible to apply for Affirm before scheduling my 1st appointment?
Hi Scott. I have forwarded your inquiry to our sales and support team who should be contacting you shortly about your question. Thanks for writing into YourMechanic.com.