Q: My front headlight is out o bough a bulb it's still not working it's a 2013 Chrysler 200 S
The front headlight was out I replaced the bulb it still isn't working
My car has 78000 miles.
My car has an automatic transmission.
Recommended Services
| Headlight is not working Inspection | $94.99 - $114.99 | Get a Quote |
Hi Michele. Thanks for contacting us tonight. There are a few possible reasons that your headlight is not working after replacing the bulb. In most cases, it’s because the electrical harness is either loose or damaged. It could also be due to an exposed electrical wire - or in some cases, the bulb you purchased may be faulty. I would double check the connection to the light bulb first. If the light bulb still doesn’t work, you can remove the bulb from the other side and install to test whether the issue is the bulb or the housing. If this doesn’t work, or you can’t figure out how to resolve this on your own, please have a professional mechanic come to your location and complete a headlight inspection.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
What tire size should I use and what inflation pressure should I set them at?
Your tires provide you with traction, stability and performance on the road. Of course, they wear out over time and you’ll need to replace them eventually. It’s very important that you replace them with the right size tires, and that...
My transmission slips out of fear at high speed but not all the time.
This is a symptom of worn or damaged gears within the transmission. It can also be a mis-adjusted shifter linkage, not allowing the gear to fully engage. If your clutch is going bad, you will notice the engine accelerate faster...
Honda Civic Si grinds going into second gear.
The second gear synchronizer is usually the first one to fail in a manual transmission. The synchronizers are devices in the transmission that match the speed of the gears before allowing them to mesh. It's that downshift to second gear...
Keep stalling when I slow down or shift gears
Engine stalling is typically caused by fuel or ignition system problems and/or faults in the air induction system (including vacuum leaks) and engine management sensors. If you request an engine stalling diagnostic (https://www.yourmechanic.com/services/car-is-stalling-inspection), the responding mechanic will go through a...
Where would the radiator drain plug be located on my vehicle? 2003 Chevrolet Impala
Hello, the radiator drain plug will be a the bottom edge of the radiator (https://www.yourmechanic.com/article/how-long-does-a-radiator-last), facing the engine (passenger side). If you drain the coolant, be sure to catch it with a pan of some sort, and properly dispose of...
VSA and engine lights both come on when I excelerate the car and it runs rough.
Hi there. The VSA (Vehicle Stability Assist) is on for an issue that deals with the engine load. Check the codes that are stored or pending in the ECM (computer) since the check engine light is on. The code should...
When I brake my my steering wheel turns to the right and car pulls to the left and make a clunk noise when I let go off the brakes
Hi there. A car that pulls to one side when braking is an indication of a potentially dangerous situation, and should be inspected and repaired as soon as possible. Some common issues that cause this include a collapsed brake caliper...
Where is the fuel injector located in a 2011 Kia Soul
Hi there. The fuel injectors are located on intake manifold on a Kia four-cylinder engine. It might be a good idea for you to purchase a service and repair manual for your 2011 Kia Soul if you're planning to do...
Hi, my name is John. I just took in 2008 Lexus ES350 for oil change, and the mechanic at Firestone is telling me that there are ga
Hi John. Thanks for writing in today. The CV boot protects the CV axle from dirt, debris and maintains lubricity as it contains a copious amount of grease. It will wear out overtime - due to exposure to elements, road...
Related articles
A Buyer’s Guide to the 2012 Chrysler 200
In In 2011, Chrysler completely overhauled, updated, and remodeled their entire line, including the introduction of the new Chrysler 200. This reimagining of the old, boring Dodge Sebring sedan was already an exciting move for Chrysler, and the 2012 Chrysler...
A Buyer’s Guide to the 2013 Mazda CX-5
Key Key Features The Mazda CX-5 has a 2.0 liter four cylinder engine that offers 155 hp at 6,000 rpm. The fuel economy is estimated at 26 mpg in the city and 35 mpg on the highway for the front-wheel...
The Best Used Cars to Buy If You Get Motion Sickness
For For people that suffer from motion sickness, even on the shortest car trip, riding in a vehicle can prove to be unbearable. What’s great is that there are a number of cars on the market that can help to...
Browse other content
Estimates
Services
Cities