My truck acts like it wants to stall when in drive but no...


My truck acts like it wants to stall when in drive but not when accelerating Mechanic's Assistant: How old is the transmission? Have you checked the fuel filters? Probly stock its an 85 cherokee brand new weber carb M...

My truck acts like it wants to stall when in drive but not when accelerating Mechanic's Assistant: How old is the transmission? Have you checked the fuel filters? Probly stock its an 85 cherokee brand new weber carb Mechanic's Assistant: What year is your Cherokee? 85 Mechanic's Assistant: Are you fixing your Cherokee yourself? What have you tried so far? New carburetor oil pan gasket new valve cover new trans filter and gasket Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? Loses acceleration after 55 unless I put pedal to floor

Automotive Expert
Hi, my name is\*\*\*\*\* to justanswer. I will be assisting you with your question today. I am sorry that you are having difficulties with your vehicle and will do my best to help you out. So, it sounds like you may have a couple of issues going on here. First, since you installed a new carb, did you replace the fuel filter? If not I would start there. Second, is your engine timing correct? That should be checked as well. Third, have you checked for vacuum leaks? They will cause a major lose in power. And of course what about fuel pressure? That will be affected by a plugged filter, but if it is low to begin with, that will have an effect on power. **\*\*As far as phone calls, If you didn't request it, it is most likely the Website prompting you, not me. A Live Call is a "Premium Service" and will cost more money. I prefer communicating via this site, but in some cases a phone call may be recommended\*\***

It doesn't start right off the bat I have to pump then start then it runs and dies, I repeat 2 more times and it starts and stays staryed
Automotive Expert
Is the choke set up properly on the new carb?

Should be it was sent pre setI'd call but im at work sorry
Automotive Expert
That's ok, I prefer chat. I would double check the choke and make sure it is working properly. A lot of times "preset" isn't always that way and they require a few fine adjustments.

What would cause it to go through 3 alternators in 4 months?
Automotive Expert
Is it possible the belt is getting over tightened and prematurely causing the alternator to fail? Is the battery new?

I've replaced all that I eventually went to a powermax its been good but I figured I'd ask just in case ya know
Automotive Expert
There are not too many reasons for an alternator to go bad. The main two reasons are due to pulley bearing failure, and the voltage regulator failing. Sometimes the remanufactured alternators do not hold up the best either.
Automotive Expert
Anything else I can assist you with?
Automotive Expert
Thanks for using justanswer.

What others are asking

What Is Engine Displacement?
Engine displacement is the total volume of an engine's cylinders added together. To figure out the engine’s total volume displacement, you would need to know the bore, which is the diameter of each cylinder, the stroke, which is the distance...
Car stuck in 4th gear.
The two codes point to two different problems. The code P0501 indicates a possible problem with the vehicle speed sensor. The code P0753 point to a possible problem to shift solenoid A in the transmission. Both of these problems could...
Car starts, but then shuts off
There are many possibilities that could cause your concern. The most likely cause would be one of the engine sensors not reading correctly. If the computer isn't getting the right info the engine may not be able to continue running...
Headlights stay on after car is turned off
Hi there. If the head lights took that long to turn off then you more than likely have a failure starting in the body control module. This is a common failure on this vehicle. I typically start by reprogramming the...
Misfire wont go away
Hi there. From your description of all that has been done. I suspect you may have a computer problem. The powertrain control module (PCM) is designed to store a fault code in pending codes, on the first drive cycle that...
Why do I have to pump the gas to crank it? It dies when I slow down to turn corners
Hello there, many common faults will cause your 2003 Chevrolet Malibu to have to have the pedal pumped to start it. Common faults would be the faulty throttle body (https://www.yourmechanic.com/services/throttle-body-replacement), throttle body linkage, fuel restriction, vacuum leak (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-a-vacuum-leak), idle air...
My temperature gauge goes to hot fast and white smoke starts rolling out from under the hood
Based on your description it sounds like your engine is overheating. Be sure not to drive the car if it is overheating because overheating can warp the cylinder head and/or engine block causing costly damage. The most common causes of...
The clutch was slipping, started working fine again, and shortly thereafter it wouldn't shift out of neutral.
If the clutch is slipping while "released" (engaged with the flywheel), the clutch friction material must be replaced as well as possibly other components such as the pressure plate, throw out bearing and other components. In addition, the flywheel has...
manual key ( no remote ) only opens and closes driver side door. other doors wont open/close.
Hi Varun. Thanks for submitting your question this morning. Usually, when you use a manual key to unlock a door, it will only unlock that individual door. I'm not 100% sure that unlocking all doors is a feature of this...