Hello! I’m having issues with a 2012 Hyundai Genesis coup...


Hello! I’m having issues with a 2012 Hyundai Genesis coupe 3.8 track, I have replaced the hpfp and fuel tank module, i get a crank with no turn over issuing code P0087 \*2013 Mechanic's Assistant: Have you noticed an incre...

Hello! I’m having issues with a 2012 Hyundai Genesis coupe 3.8 track, I have replaced the hpfp and fuel tank module, i get a crank with no turn over issuing code P0087 \*2013 Mechanic's Assistant: Have you noticed an increase in fuel consumption? And how does the Genesis Coupe start—same as usual? Does not start, it turned off while I was driving one day and since then has not been able to turn on Mechanic's Assistant: Are you fixing your Genesis Coupe yourself? What have you tried so far? Yes! I changed the Fuel tank module as well as the high pressure fuel pump Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? That is all! Thank you!

Automotive Expert
Welcome to JustAnswer Mechanical Support! I am AutoExpert20 and I will be Investigating and Supporting your question today. I understand it can be really frustrating when your auto is not working an expected but don't worry as I am here to help! I may need further information, however, if required I will let you know! Sorry to hear your having issues with your vehicle I will try to assist you. I am reviewing your information and will get back to you shortly.

Thank you!
Automotive Expert
P0087 is a relatively common OBD II trouble code. This code indicates that there is an issue with getting enough fuel pressure to the fuel rails. It’s generic, which means that it has the same meaning for the Hyundai as it would any other vehicle. This code is most common on vehicles that use a returnless fuel system. This means that the fuel pump adjusts the pressure going to the fuel rail based on the demands of the vehicle, therefore eliminating the need for a return line. I would check and test the fuel pump relay and fuses and replace if needed also carry out a fuel pressure test check the inertia switch has not activated and popped up also you could check the supply voltage to the low pressure in tank fuel pump and replace if needed.

The fuses looked fined and relay was replaced, and when I had replaced the fuel pump it seemed fine it ran that same day and the following day was when I was having that issue, I will check the fuel pressure and not sure where the inertia switch would be located
Automotive Expert
Do you have a manual it will have the location in the manual but normally it can be under the engine bay normally by the top strut bolts top wheel arch area or in the boot luggage area or even in the glove box.
Automotive Expert
Phone call session started

What others are asking

Van pulls to the right when accelerating at highway speeds
What you're experiencing is torque steer, which is the tendency for a front-wheel drive vehicle (such as yours) to pull to one side under acceleration. Some torque steer is normal in a front wheel drive vehicle. However, there are several...
shake around 45-50 mph 2006 Honda Odyssey
Hi there, thanks for writing in about your 2006 Honda Odyssey. Try to drive your vehicle in 3rd gear without overdrive on and see if problem goes away. The problem is at the speed where the lockup torque converter locks....
I had to change output the speed sensor, but my car still drive in 5 high. What do I need to do?
Hi there. Since you have replaced the speed sensor and your vehicle is still giving you the engine light code P0720 for the speed sensor circuit malfunction, then you would need to check the circuits from the speed sensor to...
what would be the average cost to own my vehicle over a ten year period
Typical "lifecycle" vehicle ownership and operation costs, such as you are inquiring about, are calculated on a 5 year interval. Going out 10 years has too much inherent uncertainly in inflation projections, and the costs of fuel, insurance, and repairs....
Jerking when accelerating.
The transmission fluid level should be checked while the engine is running at operating temperature and idling with the gear selector in the park position. If this was the case when you checked your transmission fluid and the level was...
Intermittent failure to start.
Check the starting of the vehicle in park and in neutral. If the vehicle starts all the time in neutral, then the neutral safety switch needs replaced. If the engine does not start every time on whether the transmission is...
Engine and trans replace labor hours 2010 Ford Transit Connect 2.0
Hello - unfortunately this is not a service YourMechanic offers at this time. Thanks for thinking of us though!
Can resetting 2014 Chevy captiva computer stop the reduced engine power
Hi there. Unfortunately, this is a very difficult question to answer since we don't know which codes are showing up during an OBD-II diagnostic exam. However, what the local auto parts store probably did was a code scan and not...
navigation on toyota corolla 2017
If your Corolla has the optional Entune™ Audio Plus With Connected Navigation App, then there is built in navigation. To my knowledge, Entune Audio alone does not have navigation. To be sure, simply look on the window sticker for the...