Q: How to remove rear seat in Axio 2013...?
how to remove rear seat in Axio 2013...?
Hi there. Look under the seat and you will see a lock that you would pull towards you. If there is no lock under the seat, then look for a latch near the rails on the seat and operate the latches and the seat will slide off the rails and then you can remove them from the vehicle. If you need further assistance with removing the rear seats, then seek out a professional, such as one from Your Mechanic, to help you.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Gear shifter loose
That’s a tough one to figure out without actually looking at it. There’s a roll pin and a spring to attach the lever to the column. The position of the shifter P,R,D etc, is held in place by a mechanism...
Charging system failure???????
It depends on the tools you have. If you have a voltmeter, then you can check the voltage at the battery posts (https://www.yourmechanic.com/article/how-to-check-a-car-battery) when the engine is running. When you do this, make sure that you turn on the normal...
Rear brakes are dragging
Based on your description, it sounds like your parking brake may be locking up on your rear brakes. I would recommend having your rear brakes disassembled and, using the special tool you referred to, try to compress the caliper. If...
Alarm kill Switch Cannot turn off
Most aftermarket alarm systems have some sort of control module that is tied into the ignition system to prevent the vehicle from starting. Depending on the brand and the installer, it could be under the dash somewhere or under the...
Where are all of the sensors located in this car?
Hello: Sorry, but we can't supply this information for you. First, we don't know what model of Isuzu you have, and second; we don't know what type of sensors you're referring to. Most modern cars have well over 20 of...
How do you know if you just need the bearings repacked or the entire assembly replaced?
In order to know if there is additional hub damage then you will need to disassemble the hub and inspect bearings and races. If bearings are bad then it may damage the hub.
Truck starts but only runs for a minute
The actual fuel pressure and volume should be measured. Be sure the gas is not older than three months. You do have an OBD-II diagnostic system, so check for diagnostic trouble codes and a real time scanner would help pinpoint...
Car died after going through deep puddles tried to restart and it wouldn’t.. couple hours later started up no problem?What’s wrong
When you ran through the water you may have sucked in some water into the air filter and MAF sensor and engine. This will cause the engine to stall and may even damage the engine if you suck large amounts...
Why aren't my sparkplugs sparking?
Hello, thank you for writing in. The first two components to look at are the distributor and the coil. If you have a spark tester, test light, or voltmeter, you can measure the power supply along the circuit and find...
Related articles
A Buyer’s Guide to the 2013 Mazda CX-5
Key Key Features The Mazda CX-5 has a 2.0 liter four cylinder engine that offers 155 hp at 6,000 rpm. The fuel economy is estimated at 26 mpg in the city and 35 mpg on the highway for the front-wheel...
10 Best Convertible Car Seats
Baby car seats that are 3 in 1 car seats make for the best convertible car seats for your infant. All in one car seats range from $120-490.
How to Register Your Child's Car Seat
Registering your child's car seat is important to ensure their safety. By registering the the car seat you'll be updated if there are a recalls.
Browse other content
Services
Estimates
Cities