Q: How do I add oil to my car?

Hello, it's not uncommon for the heat generated from the third stop lamp bulb to warp and distort the plastic. This would lead to a bulb that can not be removed. If you do get the bulb removed, there is...

Hello. There are a couple of things that come to mind. The wire that is not connected to anything could be the wire that is causing the problem. That wire could be shorting the turn signal system once it is...

Hello, thanks for writing in. Code P0183 (https://www.yourmechanic.com/article/p0183-obd-ii-trouble-code-fuel-temperature-sensor-a-circuit-high-input-by-jay-safford) is the code for a fuel temperature sensor A circuit, high input. This code is set off when the computer detects that the sensor is out of range. In the particular instance...

Hello! An intermittent failure of a start response can be many things - a bad ignition switch (https://www.yourmechanic.com/services/ignition-switch-replacement), starter solenoid (https://www.yourmechanic.com/services/starter-replacement), or in your case - the keys use a "raised-chip" design for security. With years of wear, the key/ignition...

Hello. I would need to know what kind of vehicle this is to know for sure what may be going on. In general, loose steering is caused by something that is worn out in the steering or suspension. I usually...

Hi there - wheel bearings are fairly durable, although pot holes cause damage and knocking noises as you are experiencing. As for whether this is safe to drive (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-a-wheel-bearing-gone), I would treat this scenario as you would driving around with...

Hi there - I believe the throttle body (https://www.yourmechanic.com/article/how-to-buy-a-good-quality-throttle-body) on your engine is worn out, specifically the throttle sensor portion of the unit (internal component). It needs to be replaced. I recommend a throttle body inspection (https://www.yourmechanic.com/services/loss-of-power-inspection) performed by a...

If the vehicle alignment (camber, caster and toe settings) is in fact correct (within manufacturer specification), the steering wheel can be centered by adjusting the tie rod ends on each side of the vehicle. If the steering wheel is off...

Hi Brandon. Thanks for contacting us today. When an engine overheats to the point that the radiator breaks, it often creates additional damage to engine internal components and electrical harnesses that power many fuel and ignition systems. Without completing an...