Q: How do I access the vanity mirrors?

One thousand dollars for a car is not much these days. I have a '94 Toyota Celica I'm driving and I paid 350 bucks for it five years ago. However, I bought it from a customer of mine who was...

The noise is not coming from the pinion seal, but the pinion bearings are bad and this is why the pinion seal is leaking. You will need to have the rear end bearings and seals replaced (https://www.yourmechanic.com/services/pinion-seal-replacement). If you'd like...

If the air flow is not as specified, then you may have the wrong cold air intake (https://www.yourmechanic.com/services/cold-air-intake-replacement) for your vehicle. The code you got for the O2 sensor does not make sense, but if it goes away after putting...

Hello there. This is a common fault with the Suzuki Vitara. The most likely causes for the squeaking noise would be the drive belt (https://www.yourmechanic.com/services/serpentine-drive-belt-replacement), axle (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement), tensioner (https://www.yourmechanic.com/services/drive-belt-tensioner-replacement), or idler pulley (https://www.yourmechanic.com/services/idler-pulley-replacement). Any of these can increase in noise...

What problem codes are set? Most often, these symptoms are the result of a failed throttle position sensor (https://www.yourmechanic.com/services/throttle-position-sensor-replacement). Traditionally, cars will have a throttle cable but your Saturn has a "fly by wire" throttle system. If the engine management...

Hello. For most Toyota vehicles the maintenance required light is different from the Check Engine Light, and come on during different circumstances. The Check Engine Light (https://www.yourmechanic.com/article/the-check-engine-light-demystified) is usually the more serious of the two, and comes on when the...

Hello, you have major internal wear of the engine. White smoke is a sign of anti-freeze being burnt in the combustion chamber this could be a head gasket failure and will cause overheating condition. The loss of oil is wear...

Whenever brake pads are replaced the brake rotors must be resurfaced on a brake lathe or replaced outright. Putting new pads on a worn rotor is a guarantee that the new pads will wear irregularly, you will have vibration, and...

If the engine cranks at adequate RPM, be sure there is adequate fuel in the fuel tank and that the fuel is not old. Download any OBD-II trouble codes that have been stored and examine those codes for diagnostic clues....