Abs light on 95 Ford ranger where is control mod located
Responses
Chris
305 days ago
Hello and welcome to just answer. My name is \*\*\*\*\* \*\*\*\*\* I will assist you today. I am sorry you are having this problem, but hopefully I can help. If you have just the rear wheel ABS [brakes](/topics-brake-ford/), then the control module is behind the center of the dash just left of the ashtray. If your truck has the 4 wheel (all wheel) ABS then the control module is in the left front area of the [engine](/topics-engine-ford/) compartment.
I hope this helps and thank you again for using just answer.
Chris
Customer
305 days ago
would worn rear shoes cause lite to be on? I have only rear abswould worn rear shoes cause lite to be on? I have rear abs only
Chris
305 days ago
Possibly I have seen that on other RWAL systems before.Chris
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
Sun visors randomly block my view, worried it will cause an accident
The sun visors on you car have a service campaign number SCT64 dated 12/01/2008 to fix visors that will not stay up. This could block your view and be a safety issue. Call ahead and take the vehicle to your...
Intermittent starting issues
Hello. There are two easy ways to test a starter. One is to measure the voltage present at the starter terminals when cranking the vehicle. Another way is to test the starter with a starting system tester directly at the...
Car misfires after distributor, rotors, plugs, plug wires replacements. 1999 GMC Savana 3500
Although the person who serviced your vehicle the first time did not repair the issue, I think he might be correct about the fact that it could be an intake manifold gasket (https://www.yourmechanic.com/services/intake-manifold-gaskets-replacement) or a fuel pump issue (https://www.yourmechanic.com/services/fuel-pump-replacement). You...
Rear brakes not grabbing - 1995 GMC K2500
Hello. It is not in the ABS, but may be the proportional valve not giving the correct pressure split front to the rear. The vehicle never had enough pressure for the rear brakes. Have the rear shoes adjusted properly if...
My brakes go all the way down and are hard to stop
If the hydraulic system was opened, for example, if rebuilt calipers were installed, then yes it could very well be that the entire four wheel system needs to be carefully bled, preferably using a pressure bleeder, and also being mindful...
Connections are different on the new alternator.
Hi there. The wiring should be the same. If the plug is the same where it hooks into the alternator, then the wiring is the same. Newer alternators have different symbols for the connections. Now, if the connections are completely...
Engine rattles around 2100 RPM and Oil light flashes
Hi there: The shakes and rattles may be due to worn engine mounts or an out of tune ignition system. It's also possible since your oil light is flashing, that your car is low on engine oil, which can cause...
My car lean to one side after changing my upper ball joints
This vehicle has ball joints that are integral with the control arms and consequently the control arms are replaced if the ball joints are worn. Replacement of the control arms, particularly the upper control arm, implicates the air ride and...
I left my car lights on. I jump started the car started it up and drove around for an hour or more. The car didn't turn on again
I suspect you have a faulty battery and I would start there. If the starter motor is not even cranking the engine, among the first possibilities is a weak battery, excessive voltage drop in the starter circuit due to poor...
Browse other content
Estimates
Maintenance
Abs light on 95 Ford ranger where is control mod located ...
Abs light on 95 Ford ranger where is control mod located