Q: Driver's headlight out

When listening to the radio, you may find the need to turn the volume up or down. There is a Volume knob built into the radio to help you adjust the volume at any time. To adjust the volume. Turn...

If the engine doesn't crank but only makes a grinding or clicking noise, my guess is that the starter is bad. This can be verified using a dedicated starting/charging system tester, or by using a digital multimeter. A trained professional,...

This can often times happen when the ABS system is activated which is usually activated when driving over rough surfaces or bumps. The ABS system will trigger warning lights and typically cause a momentary lapse in traction control as the...

Hello. It sounds like you need a brake switch replacement (https://www.yourmechanic.com/services/brake-light-switch-replacement). These switches are a common failure. I usually test the switch with an ohm meter, which will tell me if it is bad. There are also other parts of...

Hello. I would recommend taking the car to have the alignment (https://www.yourmechanic.com/article/why-is-it-important-to-have-a-vehicle-s-suspension-aligned) checked. Sometimes when the car is not properly aligned this can cause a shaking effect. At the same time, you may also want to have the wheels and...

It is not uncommon for an ignition coil to fail (https://www.yourmechanic.com/services/ignition-coil-replacement). Ignition coils are coated with a varnish-like insulation that becomes brittle over time after being stretched then contracted repeated as the copper beneath them expands and contracts much quicker...

The most common cause of noise in the front of the motor having to do with the accessories is the tensioner and idler pulley bearings get noisey. I have also seen where the a/c compressor pulley bearing gets noisey. You...

If the thermostat is not open yet then the thermostat will not let enough fluid to flow into the heater core. You should have both heater hoses into the heater core hot when idling. You should let the engine run...

This problem is reported for this model, by other consumers, in the NHTSA database (http://www.safercar.gov). Some reported fixes have involved removing power from the battery as a "re-set". Also, sometimes an improperly adjusted shift cable is the cause. There is...