I have a jag Xjs aj6 6 cyl engine that draw oil into the ...


I have a jag Xjs aj6 6 cyl engine that draw oil into the throttle body. I can not find ANT filter or breather onthe engine Mechanic's Assistant: When was your last oil change? Every 5000 km Mechanic's Assistant: W...

I have a jag Xjs aj6 6 cyl engine that draw oil into the throttle body. I can not find ANT filter or breather onthe engine Mechanic's Assistant: When was your last oil change? Every 5000 km Mechanic's Assistant: What year is your XJS? 1993 Mechanic's Assistant: Are you fixing your XJS yourself? What have you tried so far? I have tried nothing yet. Allways read and Ask first

Automotive Expert
Hello and thank you for using JustAnswer. My name is \*\*\*\*\* \*\*\*\*\* I will do my best to assist you. During this conversation you will be given an automated offer for a phone call. You may accept or decline that offer.I don’t personally offer this service so if you take this another tech may call I’m sorry that you’re having trouble with your vehicle. I will do my best to help you resolve them. Please understand that I do not know your knowledge or capabilities so I may need to ask questions to find out basic information to help solve your specific problem. My aim is to give you the best service possible and to help you. If you have any questions or concerns, please don’t hesitate to let me know. Sometimes it may take a moment for me to respond because I may have to look up information about your concern. I appreciate your patience and will provide responses as soon as possible. Ok, the pcv system has a control orifice in line between the valve cover and the oil filler tube. When this is faulty it will cause oil to go into the throttle body and intake manifold. SEE ATTACHED DIAGRAM I have attached the directions as a pdf file. click on the link below. If you are on a mobile device, it may not show. In that case, go to your emails and open the last one from justanswer and it will be attached there Thanks for using Just Answer and letting me help you. I hope I provided what you needed. If you find more help is still needed, let me know by listing out any remaining questions you have on this concern. I hope the remainder of your day is well.

Thanks! That is givning me a good start! I think I can go on from here.
Automotive Expert
hi you are welcome and always happy to help out

Thanks! This will giv me a good start. I think I can go on from here. ��
Automotive Expert
you are welcome

What do I do now to stop our conversation? Thanks again.
Automotive Expert
HI just do not reply back to this post and it will time out

What others are asking

What does the Master warning light on the dash mean?
The Master Warning Light is usually accompanied by another warning light, and indicates that one or more warning systems have been detected. The Master Warning Light ranges in its levels of significance and severity. It is important to check your...
How do you operate the fog lights?
If your car is equipped with fog lights, they can provide better illumination of the road when you drive in misty or foggy conditions. Here’s what you need to know about operating them: Turn the ignition on. Turn the headlight...
Passenger door won't open
Hello. It is possible that the door actuator is stuck in the lock position, causing the passenger door to jam. It is also possible that there is a problem with the door latch; if the latch won’t release when the...
ECT Engine Coolant Sensor Removal
The tool is an open end wrench or a line wrench that should be a 3/4 inch for most sensors of this type. Take the new sensor with you to get the exact size you need since some were a...
Driveshaft assembly
Hello, thanks for writing in. The driveshaft assembly is composed of the driveshaft, U-joints and snap rings. Both ends of the driveshaft connect to the output shaft and differential via yokes. If you would like help with this replacement, consider...
Blowing cold air no heat
Since the thermostat has been replaced, there are a couple of other things to look at. The heater hoses going through the firewall in the engine compartment to the heater core behind the dash should be checked. They should be...
P0128 - Coolant Thermostat had a fault 2007 Nissan Sentra
Hello - your thermostat is not functioning properly (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-thermostat), and should be replaced. The problem code is indicating that the engine temperature is not coming up as quickly as it should - which the thermostat controls. You have noticed this...
Car running really rough
Hi There, If you have tested and checked all coil packs and spark plugs with everything checking out properly, it may be likely that your issue is related to fuel delivery such as low fuel pressure or potentially a dirty...
Engine light on with P0171 code
The cause behind diagnostic trouble code P0171 (https://www.yourmechanic.com/article/p0171-obd-ii-trouble-code-system-too-lean-bank-1-by-andrew-quinn) is easiest to find by looking at the secondary firing patterns on the Bank one cylinders. That will confirm if the too lean condition, that has caused the code to set, affects...