Hi I have a 2008 Audi A4 2.0t and it’s calling for code p...


Hi I have a 2008 Audi A4 2.0t and it’s calling for code p2146 I had the injectors replaced and the same problem Mechanic's Assistant: Just to clarify, what's the exact code? And have you tried to reset it? The code is p21...

Hi I have a 2008 Audi A4 2.0t and it’s calling for code p2146 I had the injectors replaced and the same problem Mechanic's Assistant: Just to clarify, what's the exact code? And have you tried to reset it? The code is p2146 injector a supply voltage circuit is open and yes I did reset but still no start Mechanic's Assistant: Are you fixing your A4 yourself? What have you tried so far? Replacing The injectors Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? Yes it just crank but no start but if I use starting it try to start and cut off

Automotive Expert
Hello and thanks for choosing JustAnswer. My name is\*\*\*\*\* have been on JustAnswer since it's beginning in 2009 and working on cars since 1992. I’m a factory master technician and specialize in of German vehicles and high line vehicles. For a little more about me click or copy and paste this link https://www.justanswer.com/car/expert-wolfgangz I do realize that this is an inconvenience and sorry that you have this issue. I took your question because I either have experience with your issue or I know I can help get you in the right direction if not fixed up. I am online daily 8am -8pm eastern time zone. 1. May I have your name please? 2. In order to assist you better I do need the VIN # of the vehicle to get the factory information to assist Thanks

What others are asking

Car blowing cold on one side, hot on the other
That sounds about right. There have been a lot of cases with faulty actuators. They are computer controlled. If a code is set, they will default to a set position, or it's stuck. The blend door itself could be stuck...
Shifting issues, skipping gears and jerking while letting off the gas
The transmission case servo pin bore gets worn out. To repair this is to drill the hole out, and install a sleeve bushing to repair the transmission housing. The transmission will need to be removed, and taken apart to do...
Evaporation Emission System
This is not a common problem when it comes to evaporation emission systems. Although, it is not possible to tell how it may have been ripped out, I would recommend getting a second opinion by another qualified mechanic such as...
Oil light goes off and on.
This light will usually come on when one of two things are happening. Either the motor is in fact low on oil or the oil pressure sending unit (https://www.yourmechanic.com/services/oil-pressure-sensor-replacement) is not working properly and may be producing a faulty reading....
High pitch noise comming from right side of the engine ( when you're in the cabin its right)
Hello. This can be caused by a few different things. Most of the time it is caused by an issue with the air intake tube not being tightened securely.If any of the clamps on the intake are loose then this...
My car has suddenly started wandering when shifting
Hi there: In most cases, the symptoms you're describing are caused by problems with tires, suspension components or the steering rack. When you shift into a different gear during acceleration, the suspension and tires must work together to ensure the...
Car won't start, can smell gas, started 10 min later.
Hi There, This is likely related to your EVAP emissions system and something called a purge valve solenoid. The EVAP system prevents fuel vapors from the fuel tank from escaping into the atmosphere. The EVAP system collects and temporarily stores...
Charging issue, New alternator/battery
Hi Christian. Thanks for contacting us tonight. An alternator is a mechanical system. Failure of an alternator is typically due to one of three sources. Either the internal components of the alternator fail (which is common sooner in refurbished alternators...
when I break my car goes back and forward
It is possible that you have warped brake rotors or loose suspension parts. I would recommend having your vehicle inspected by a qualified professional to determine if any free play in suspension parts or run-out in the brake rotors exists....