Toyota Tundra Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(528)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(528)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Toyota Tundra Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2001 Toyota TundraV6-3.4LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2014 Toyota TundraV8-4.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2010 Toyota TundraV8-4.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2011 Toyota TundraV6-4.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2010 Toyota TundraV8-5.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2016 Toyota TundraV8-5.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2017 Toyota TundraV8-4.6LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2007 Toyota TundraV8-4.7LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Toyota Tundra Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Toyota mechanics

Real customer reviews from Toyota owners like you.

Excellent Rating

(528)

Rating Summary
499
16
1
4
8
499
16
1
4
8

Terry

26 years of experience
326 reviews
Terry
26 years of experience
Toyota Tundra V8-4.7L - Car starts and then dies - Glendale, Arizona
Terry exceeded my expectations by getting the job done in a timely manner. His services will always be invited over here.

Marcus

19 years of experience
25 reviews
Marcus
19 years of experience
Toyota Tundra V8-5.7L - Car starts and then dies - Lakewood, California
Marcuss was great!! he showed up on time, friendly and professional. He ran a diagnostic on my truck to figure out what was wrong with it and when he was complete he provided recommendations to fix the problem and he was spot on, my truck is up and running like used to.

Scott

22 years of experience
49 reviews
Scott
22 years of experience
Toyota Tundra V8-5.7L - Car starts and then dies - Paradise Valley, Arizona
Scott was on time he knew what he was doing and how to do it. He worked hard even though it was extremely hot. HOWEVER my truck now makes a extremely loud noise upon starting. Have no idea what or why or if I am doing damage to this vehicle by using it!

Andrew

23 years of experience
169 reviews
Andrew
23 years of experience
Toyota Tundra V8-4.7L - Brake Pads Replacement (Front) - Garland, Texas
Andrew is the Man!! I'll be having him back over for more work on my Tundra nest month.

Excellent Rating

(528)

Rating Summary
499
16
1
4
8
499
16
1
4
8
Number of Toyota Tundra services completed
5808+
services done by our mechanics
TOTAL NUMBER OF EXPERT Toyota MECHANICS
1600+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2012 GMC Canyon
In In today’s world where it seems as if carmakers are determined to deliver only the largest vehicles possible, the 2012 GMC Canyon offers a compact pickup that holds its own. From a 4-cylinder that offers more horsepower than other...
A Buyer’s Guide to the 2012 Kia Optima Hybrid
Kia Kia has really turned over a new leaf with their cars in the past few years, and the 2012 Kia Optima Hybrid is certainly no exception. With the same attractive design as the Optima, higher fuel efficiency, and a...
How to Be a Professional Race Car Driver
Few Few sports are as full of adrenaline and excitement as car racing. There’s a reason that little kids love their Hot Wheels model cars, and pre-teens love playing racing video games, and teenagers can’t wait to get behind the...

Brakes have gone out

Hi there. The first thing that needs to be determined is if there is a failure of a line or brake component, such as, a brake hose, caliper, or wheel cylinder. The brake fluid level needs to be checked to...

Where is the TCC Solenoid location on a 97 cavalier?

The TCC solenoid location is in the front of the transmission on the top of the valve body (brain of the transmission) in the side pan. If you need further assistance with your TCC solenoid location or replacement, then seek...

I have a very loud knocking sound from the front driver side of my 1991 Jeep Cherokee Laredo 4x4

Hi Taylor. Thanks for contacting us tonight. A loud knocking sound coming from your front wheels can be caused by wheel bearings or inner transaxle components. If the noise does not come on during reverse, then it's likely a forward...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com