Chevrolet Monte Carlo Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(258)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(258)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Chevrolet Monte Carlo Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2001 Chevrolet Monte CarloV6-3.4LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1999 Chevrolet Monte CarloV6-3.1LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1985 Chevrolet Monte CarloV8-5.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1981 Chevrolet Monte CarloV8-4.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1980 Chevrolet Monte CarloV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2004 Chevrolet Monte CarloV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1986 Chevrolet Monte CarloV8-5.0LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2005 Chevrolet Monte CarloV6-3.8LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Chevrolet Monte Carlo Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(258)

Rating Summary
231
10
2
0
15
231
10
2
0
15

Joel

21 years of experience
987 reviews
Joel
21 years of experience
Chevrolet Monte Carlo V6-3.8L - Car starts and then dies - Jacksonville, Florida
Joel arrived in the time frame specified. Very friendly, courteous, professional and qualified. He was able to assess and fix the problem preventing the car from staying started. Joel also recommended other areas that needed service. Highly recommend him to service your vehicle.

Joseph

27 years of experience
578 reviews
Joseph
27 years of experience
Chevrolet Monte Carlo V6-3.9L - Throttle Body - Houston, Texas
Excellent

John

20 years of experience
568 reviews
John
20 years of experience
Chevrolet Monte Carlo V6-3.8L - Car is overheating - Orlando, Florida
john is very friendly and professionally he let me know step by step of what he were doing very great guy he were on time did a very outstanding job I will truly use his service again and recommend

David

16 years of experience
635 reviews
David
16 years of experience
Chevrolet Monte Carlo V6-3.8L - Cooling/Radiator Fan Motor - Sacramento, California
Fast and friendly did a great job.

Excellent Rating

(258)

Rating Summary
231
10
2
0
15
231
10
2
0
15
Number of Chevrolet Monte Carlo services completed
2838+
services done by our mechanics
TOTAL NUMBER OF EXPERT Chevrolet MECHANICS
1600+
experts on our platform

Recent articles & questions

How to Buy a Personalized License Plate in Michigan
A A personalized license plate can be a really fun addition to your car. With a personalized plate, you can add a little bit of your personality to your vehicle, and make your car uniquely you. It’s an opportunity to...
B1898 OBD-II Trouble Code: Chime Input #2 Circuit Short to Ground
B1898 means there is a circuit issue with chime input 2, most likely due to a damaged electrical component.
How to Replace a Pitman Arm Shaft Seal
The pitman arm attaches to the steering box via a shaft. To prevent leaks and driveability issues, the pitman arm shaft seal is used on this shaft.

Car makes metal-on-metal noise on startup

The most likely cause of the noise is starter motor gear clash, or the starter and flywheel. The fix is to remove the starter, replace it, and check the flywheel for any damage. Sometimes, the starter drive binds and causes...

Hesitation when accelerating.

You may have spark plug wires that are damaged or the plug you put in got damaged while putting it in the hole. If you accidentally closed the plug gap then the plug will cause a misfire. I recommend removing...

Motor Mount

Motor mounts will allow the motor to move too much when accelerating. If you feel motor move when you give it gas and may hear clunk. The motor mounts should be checked. If engine runs rough it may be something...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com