Cadillac STS Brake Drum Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Brake Drum Replacement Service

How much does a Brake Drum Replacement cost?

On average, the cost for a Cadillac STS Brake Drum Replacement is $374 with $212 for parts and $161 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
2010 Cadillac STSV6-3.6L	Service typeBrake Drum Replacement	Estimate$619.72	Shop/Dealer Price$755.54 - $1096.03
2010 Cadillac STSV8-4.6L	Service typeBrake Drum Replacement	Estimate$585.72	Shop/Dealer Price$721.59 - $1062.13
2005 Cadillac STSV8-4.6L	Service typeBrake Drum Replacement	Estimate$585.72	Shop/Dealer Price$721.59 - $1062.12
2009 Cadillac STSV8-4.6L	Service typeBrake Drum Replacement	Estimate$585.72	Shop/Dealer Price$721.52 - $1062.00
2008 Cadillac STSV6-3.6L	Service typeBrake Drum Replacement	Estimate$585.72	Shop/Dealer Price$721.63 - $1062.20
2008 Cadillac STSV8-4.6L	Service typeBrake Drum Replacement	Estimate$585.72	Shop/Dealer Price$721.59 - $1062.12
2006 Cadillac STSV6-3.6L	Service typeBrake Drum Replacement	Estimate$594.22	Shop/Dealer Price$729.68 - $1069.91
2009 Cadillac STSV6-3.6L	Service typeBrake Drum Replacement	Estimate$594.22	Shop/Dealer Price$730.79 - $1071.85

Show example Cadillac STS Brake Drum Replacement prices

What are brake drums and how do they work?

A brake drum is a heavy, cast iron brake system part that looks like a shallow, several inches-high cylinder about 9 to 12 inches in diameter. The brake drum has a precisely machined surface all around the interior circumference, that the brake shoes make contact with when you apply the brakes, transmitting hydraulic pressure through the wheel cylinder. This forces the brake shoes outward against the interior of the brake drum, resulting in the friction that causes the car to slow. The brake drum is mounted over, and fully encloses, all of the rear brake components such as the wheel cylinder, springs and clips, brake shoes, and parking brake mechanism. The drum is commonly held to the wheel hub by the wheel and the lug nuts, but some configurations combine the drum with the wheel hub as one unit. Nowadays, a drum brake type system is only installed on the rear axle, if used at all, as 4 wheel disc type systems have become more common.

When to consider replacing brake drums:

Reduced braking effectiveness. If the brake drum is unevenly worn, scored or cracked, it will increase stopping distances. A cracked drum must be replaced outright but a worn drum can be restored on a brake lathe so long as enough metal material remains.
Pulsating brakes, pulling to one side, vibration or noise. If a brake drum is warped, is unevenly worn, or perhaps the brake shoes have worn down completely — creating metal-to-metal contact — you might detect pedal pulsation, the vehicle may pull to one side, or you might feel a vibration or hear a noise when you apply the brakes. The brake system will have to be inspected to pinpoint the exact problem.
Brake shoe replacement. Anytime the brake shoes are replaced, the drum must either be resurfaced or replaced outright. Installing new brake shoes on a used, unresurfaced drum will lead to poor results.
Loss of parking brake function. The parking brake locks the brake shoes against the brake drum. If the brake drum is cracked, the parking brake lever will pull up excessively and the car may still be able to roll. However, a more common circumstance is parking brake maladjustment or seizure of parking brake components. Repair of those problems will often require removal of the brake drum.

How do mechanics replace brake drums?

There are two options when it comes to brake drum service: outright replacement or resurfacing. In some cases, it is cheaper to replace the drum rather than refurbish it. In both cases though, the removal and installation procedure for the drum is the same.

Raise the vehicle and safely support it using steel jack stands.
Remove tire and wheel assembly.
Remove brake drum. Sometimes the brake drum has rusted to the wheel hub and removal of the drum will require a brake drum puller. In some cases, the wheel hub is integral to the brake drum, in which case the hub-bearing retaining bolt and the wheel bearing must be removed to replace the drum.
Measure the interior diameter of the machined surface in the drum with a brake drum micrometer or similar measuring tool. If sufficient metal exists to resurface the drum on a brake lathe, the mechanic will compare the cost of such restoration to the alternative: buying a new drum.
Prior to installing the resurfaced or new drum, the brake shoes, springs, wheel cylinder, parking brake mechanism, and backing plate are all inspected. All worn parts should be replaced. Generally, if drums have been replaced or resurfaced, new brake shoes should be installed. The worn shoes will cause irregular wear in the brake drum and reduce braking effectiveness.
The shoes are adjusted and the drum is installed. The wheel and tire assembly are installed and torqued in the proper sequence and the car is road tested to check the operation of the brakes.

Is it safe to drive with a brake drum problem?

No. Should there be a deficiency with the brake drums, stopping distances will not be as short as possible. In a panic stop, stopping just five or ten feet shorter could be the difference between no collision and a collision. Any deficiency in a vehicle’s braking system is a cause for concern and a potential safety issue. Have the brake drums inspected at your earliest convenience to determine if a problem exists and find out what must be done to fix it.

When replacing brake drums keep in mind:

With few exceptions, brake work on one end of an axle should be performed on both ends of the axle. Should a brake drum on one end of a front or rear axle be serviced, or brake shoes on one end are serviced, both sides of the axle should receive the same service. This helps to avoid problems, such as pulling, vibration, and so forth, once the vehicle is returned for use.
Brake drum systems use very powerful springs to keep the brake shoes in position. These springs are exposed to extreme heat. It is best practice to replace all springs whenever new shoes are installed. Should a spring unexpectedly break in the brake drum assembly, a mispositioned brake shoe could cause the brakes to grab and lock, which would pose a safety issue.
If the wheel hub and bearing are integral to the brake drum on your car, the mechanic may recommend replacement of the grease in the wheel bearings and inspection of the wheel bearings.
Since the arc of the brake shoes will not perfectly match with the arc of the drum when new, expect a bed-in period before maximum braking efficiency is achieved.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Cadillac mechanics

Real customer reviews from Cadillac owners like you.

Excellent Rating

(114)

Rating Summary

103

5

1

3

2

103

5

1

3

2

SEE REVIEWS NEAR ME

Luis

17 years of experience

62 reviews

Luis

17 years of experience

by Kyle

Cadillac STS V8-4.6L - Battery Cable Replacement (Positive, Negative) - Kissimmee, Florida

Luis was early for my appointment. Notified me that I needed a battery replacement. I went and got it while he continued working. He the. Notified me after the battery cables were replaced that the starter also needed to be replaced. He was able to get it the same day not like the Cadillac dealer who first looked at my car. He returned and finished the work. This services saved me 50% verses the dealer with the same warranty. I have already scheduled my next service for my 2002 Tahoe for a water pump & thermostat replacement.

Chris

22 years of experience

2229 reviews

Chris

22 years of experience

by Michael

Cadillac STS V8-4.6L - Spark Plugs - Menifee, California

Great service and real quick

Harish

27 years of experience

588 reviews

Harish

27 years of experience

by Michael

Cadillac STS V6-3.6L - Car is shaking or vibrating - Charlotte, North Carolina

Very helpful, knowledgeable and informative. Would definently book again.

Mostafa

19 years of experience

62 reviews

Request Mostafa

Mostafa

19 years of experience

Request Mostafa

by Ivon

Cadillac STS V6-3.6L - Water Pump Replacement - Powder Springs, Georgia

Mostafas Was very professional. Got the job done well before time. I highly recommend him

Excellent Rating

(114)

Rating Summary

103

5

1

3

2

103

5

1

3

2

SEE REVIEWS NEAR ME

Recent articles & questions

2012 Hyundai Elantra vs. 2012 Ford Focus: Which One Should I Buy?

The Hyundai Elantra and the Ford Focus are both offerings in the inexpensive compact sedan category, and both represent some of the best offerings in that class. Compact cars are slightly larger than a subcompact, but smaller than a mid-size;...

Symptoms of Bad or Failing Brake Pads

If your brakes are noisy, the brake pedal is pulsating, or the brakes are responding poorly, you may need to replace the brake pads.

How to Know What Kind of Hoist to Buy

When When it comes to vehicle repairs, maintenance, and storage, there is a segment of the population that takes it very seriously. Professional-grade tools, large home garages or shops, and even vehicle hoists are part of their repertoire for completing...

My car makes a very odd beeping noise, what gives?

Hi there. This is most likely a service reminder indicator chiming. Take note of any messages on the display panel. It could also be the seat belt reminder chiming. This could be due to the belt being unfastened or the...

I saw this car, and the owner is selling it,

Vehicles that were badly wrecked will usually get a salvage title (https://www.yourmechanic.com/article/what-is-the-difference-between-a-clean-title-and-a-salvage-title), which means the vehicle damage was estimated to be more than roughly 70% of the value of the vehicle (https://www.yourmechanic.com/article/how-to-calculate-the-value-of-a-salvaged-car-by-jason-unrau). Also, from personal experience, anyone with a salvage...

When reversing after car sits overnight, there is a loud clunking sound coming from left rear. Seems to stop once car warms up. Ca

Hi Corinne. Thanks for contacting us today. Sometimes, this type of problem is an indication of a wheel bearing that is starting to wear. As the wheel spins, it will build-up heat and the noise can go away. However, over...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com