Audi A4 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(396)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(396)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Audi A4 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2004 Audi A4V6-3.0LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2017 Audi A4L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2005 Audi A4L4-1.8L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2005 Audi A4L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2005 Audi A4V6-3.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2000 Audi A4L4-1.8L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1998 Audi A4V6-2.8LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$117.28 - $130.25
2016 Audi A4L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$117.94 - $131.39
Show example Audi A4 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Audi mechanics

Real customer reviews from Audi owners like you.

Excellent Rating

(396)

Rating Summary
363
15
2
2
14
363
15
2
2
14

Chris

15 years of experience
312 reviews
Chris
15 years of experience
Audi A4 L4-1.8L Turbo - Car starts and then dies - Chula Vista, California
Chris was great he diagnosed my car’s problem right away and gave me options on how to beat fix the problem. Very professional

Chris

22 years of experience
2263 reviews
Chris
22 years of experience
Audi A4 L4-2.0L Turbo - Oil Change - Huntington Beach, California
He s the man !!

Clark

16 years of experience
18 reviews
Clark
16 years of experience
Audi A4 L4-2.0L Turbo - Brake Pads Replacement (Rear) - Portland, Oregon
Punctual. Great service. Expert.

David

36 years of experience
195 reviews
David
36 years of experience
Audi A4 V6-3.0L - Car is making a noise - Los Angeles, California
Today, David came in and did an inspection on my dying audi a4. I've have been to many other mechanics that I personally known, but they all failed to give me the correct inspection and the conclusions. When David arrived, he was friendly, professional, caring, and dedicated. after the very quick but I must say, VERY thorough inspection, he insisted to drive a long ways taking time of of his personal schedule to come to the dealer that sold me this car to confront them about the smog issues. all throughout the process, I must say that not only did i get more information than I ever though I could receive, but I've also made a connection and most importantly, a friend. I do not write reviews hardly ever, but you would honestly had to be a mad man to not write a review on such a mechanic that literally pours out his heart to your car and to you personally. I HIGHLY recommend this mechanic! thank you David Martin!

Excellent Rating

(396)

Rating Summary
363
15
2
2
14
363
15
2
2
14
Number of Audi A4 services completed
4356+
services done by our mechanics
TOTAL NUMBER OF EXPERT Audi MECHANICS
700+
experts on our platform

Recent articles & questions

How to Replace a Head Gasket
The cylinder head gasket is a seal located between the engine block...
P2433 OBD-II Trouble Code: Secondary Air Injection System Air Flow/Pressure Sensor Circuit High Bank 1
Diagnostic Diagnostic Trouble Code (DTC): P2433 P2433 code definition Secondary Air Injection System Air Flow/Pressure Sensor Circuit High Bank 1 Related Trouble Codes: P2430: Sec Air Inj Sys Airflow/Press Sensor Circ Bank 1 P2431: Sec Air Inj Sys Airflow/Press Sensor...
What Does the Hybrid Drive System Malfunction Warning Light Mean?
The hybrid drive system malfunction light turns on when an issue is detected with the system. It could be due to problem with the battery or a fuse.

Engine power loss and odor from the exhaust

Hello. The symptoms you are experiencing can be caused by a wide variety of issues. It may be possible that the vehicle has suffered a component failure, perhaps at the fuel or ignition systems, which is setting off the light...

should seals be replaced while in there? camshaft and crankshaft seals as well as timing cover seal.

Hi there: Anytime you remove the timing cover you should always replace the seals; as they are easy to access since "you're already in there". In order to give you further information about your belts, we need to know the...

Was told mount broke off..and need to replace 3 to secure transmussion..also that bed housing could be damaged

What you are describing is possible. Vehicle components can only withstand so much force and beyond that they will break. As far as the bell housing of the transmission, if that housing is cracked, replacing that is a fairly significant...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com