Q: Where is the purge valve located on a Mazda 626
Looking for the location of that part
Hey there. On a 2000 Mazda 626 2.0L it is in the passenger side of engine compartment on the firewall. If it is a 2.5L, then it is under and near the brake master cylinder.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Car won't crank
Hello. There are many reasons why a car wont turn over. A bad starter, a bad connection at the battery or starter, low battery voltage, bad starter relay are just a few. Because of the limited amount of information and...
Rattling on a 2005 Subaru Forester
Yes, the catalytic converters would often rattle. Catalytic converters look like mufflers but they are not. They have platinum inside these ceramic pieces and the hot air goes through them and burns hydrocarbon. What happens is, the ceramic parts start...
When you start the vehicle it will turn but shuts off, why?
It could be a number of things, but I feel the most likely cause is your key and immobilizer. If you have a spare key, try starting with the spare and see if that works. If it stays running, the...
AC belt makes squealing noise
The belt on your 2000 Plymouth Voyager is used by the engine to turn the A/C pulley along with the water pump, power steering pump, and other accessories. Any one of these items could be the cause of the belt...
Engine lost power and EPC light came on
Hello. If the dealership follows the proper rebuild procedures there should be no real cause for concern, however there are a few things you can do to protect yourself from a repeat failure. Primarily, you can choose to have the...
Truck clicks one time but wont turn over.
Hi there. If the starter was replaced, first check the battery cables (https://www.yourmechanic.com/services/service-battery-cables) to the starter and make sure that they are tight. If the cables are tight, then the issue could be that the clutch may have broke causing...
Immediately after engine turns over power steering and dashboard loses power but comes back on after the car warms up.
Check to see if there is any loose wiring under the dashboard and if there is any loose ground wires. A loose wire will cause a circuit or multiple circuits to stop working. The wiring could be associated with a...
I have nissan Teana 230 JM. Engine is getting hot and some smoke is coming when running 20-30 kms, but not showing any warning...
Of course, first make sure that the engine is fully and correctly configured for CNG. If not, that alone will create problems, including overheating. If the engine is configured for CNG but it is still overheating, you can request an...
2013 hyundai genesis 2.0 turbo how much to replace the chutch
Depending on what needs to be replaced the price to replace may vary. If the clutch pack is burnt, this may be one component of what needs and if it needs a throughout bearing, this may be an additional component...
Related articles
The Best Used Cars to Buy If You Don’t Have Kids
Buying Buying a used car is rarely a simple process, but if you don’t have kids, you have many more options than those who have to account for additional passengers. There are plenty of choices out there, depending on your...
The Best Used Cars to Buy If You're a Personal Assistant
As As a personal assistant, you have a lot of demands placed on your time. Often it’s important that you be able to get around town quickly, running a ton of errands, picking things up here, dropping them off there,...
Symptoms of a Bad or Failing Proportioning/Combination Valve
If your rear brakes are locking up, especially on wet surfaces, you should have a mechanic inspect the proportioning/combination valve.
Browse other content
Estimates
Maintenance