What could cause my car moving forward when putting it on...


What could cause my car moving forward when putting it on reverse to move backward? ...

What could cause my car moving forward when putting it on reverse to move backward?

Automotive Expert
Hi! My name is \*\*\*\*\* \*\*\*\*\* I will be able to assist you. I’m sorry that you’re having trouble with your vehicle. Don’t worry though, we’ll be able to figure this out. Please understand that I do not know your knowledge or capabilities so I **may** need to ask questions to find out basic information to help solve your specific problem. Sometimes it may take a moment for me to respond because I may have to look up information about your concern. I appreciate your patience and will provide responses as soon as possible. Are you on a hill when this happens?
Automotive Expert
With the limited information given, if it's on a hill rolling forward when in reverse then your reverse gear is gone and you will have to rebuild/replace your transmission. My goal is to earn a 5 star rating experience. Do you have any questions? Please feel free to reply back to me. If I’m not online at the time, I will respond ASAP when I get back. You can also request me in the future for any additional questions by using "Ask me a new question" option on your “My Questions” page or by visiting my profile (you can add me to your favorites also). Have a great day, thanks for being awesome, and thank you again for choosing JustAnswer!

What others are asking

Alarm went off in Panic mode
This sounds like a good time to check the owner's manual to see if it mentions this at all. If it's an aftermarket alarm system, it may need to be manually reset through a certain procedure that is model specific....
Water getting into car
Hello. During it's operation, the air conditioning system will come across a large amount of condensation. This condensation gathers around the evaporator and runs off through a drain. You may see water dripping from the car on a hot summer...
When the gas is pressed, the RPM increases, can't accelerate
From what you are describing with the RPMs going high and the vehicle not moving, it sounds like you have a transmission that is not shifting or is slipping. There is a technical bulletin that may stop the flare and...
Battery dead in 2 days
Hello. Thanks for writing in about your 2007 Lexus LS460. If the battery is draining that fast you either have a faulty battery (https://www.yourmechanic.com/services/battery-replacement) or a possible parasitic draw draining the battery down. The battery should be charged (https://www.yourmechanic.com/article/how-to-recharge-a-car-battery) and...
Car rattle noise in the middle of console - 2006 Chrysler 300
Hey there. I recommend having an expert drive the vehicle to verify the noise so the noise can be isolated to an engine or transaxle problem. With the symptoms you describe, a rattle that only happens over 40 mph may...
Radio Upgrade RA2 to RA4 how do I obtain UCONNECT access for APPS like Yelp?
Hello. In order to access the rest of the features you are looking for it is likely that you will have to download the smartphone app and provide a few details about the vehicle, as well as activate connection to...
Car is sputtering when warming up in the morning.
Hi There, If the sputtering only happens when the engine is cold during warm up, this may suggest you have a problem with the cold start injection system. When you start your vehicle in the morning and turn the key...
Check Engine Light on and off, reader gives P0446 error 1999 Toyota Corolla
Hello - the P0446 (https://www.yourmechanic.com/article/p0446-obd-ii-trouble-code-evaporative-emission-control-system-vent-control-circuit-malfunction-by-spencer-clayton) code is an indication that the evaporative emissions purge valve electrical circuit has had a loss of electrical power to the vent valve that allows fresh air to enter the evap cannister. This could be...
I changed my foglights to led's and when I tried to start the car it did not start all kind of photo showing up and my I drive scr
Hello, thank you for writing in. The first thing to check is the installation. Make sure the power supply was hooked up correctly, as LEDs are polarized and must be wired perfectly. Secondly, you want to make sure the wires...