I have a 2008 Tacoma, 4WD. I was told today by a mechanic...
Responses
K. Wiggins
319 days ago
Hello and welcome to just answer! Sorry to hear you're having this issue. Together I'm sure we can resolve the problem. I am looking over your issue and will return shortly
Customer
319 days ago
Ok!Sorry, not for $26...
K. Wiggins
319 days ago
Thanks for your patience, One you remove the u joint you can drive the bearing off after removing the yoke. Just be sure to mark orientation oh the shafts for balancing purposes. Below is the complete info
Customer
319 days ago
Thank you!
K. Wiggins
319 days ago
My pleasure, good luck with it, and thanks for using just answer!
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
What kind of fuel should I use?
You should use unleaded gasoline, with an octane number of 87 or higher.
My jeep will sometimes start and sometimes it wont.
Hello. Even though your lights and radio are still working, the battery may still not have enough voltage to engage the starter. Use a multi meter to ensure your battery is testing at least 12.6 volts. Next, test your alternator...
Rattling Sound - 2007 Subaru Impreza
Hey there. I suspect you have an engine-mounted bracket that is touching a heat-shield or other metal component under the hood, generating the noise you hear. Get a helper to hold the brake, and put the car in gear while...
Car stalling while driving - 2006 Pontiac Grand Prix
Hi there. The P0033 OBD-II error code (https://www.yourmechanic.com/article/p0033-obd-ii-trouble-code-turbo-charger-or-supercharger-bypass-valve-control-circuit-deleted-by-john-nelson) is a generic code that typically indicates a problem with the Turbocharger or Supercharger Bypass Valve Control Circuit. In most cases, the reason the code is triggered is due to a vacuum...
It got really cold the next morning. I went to start my car and my belt will not turn. I drove it the day before the cold no problem.
Hi there. There could be a few things that could be going on. Either the battery (https://www.yourmechanic.com/services/battery-replacement) was low on a charge or low on water and froze up causing the vehicle not to start up, or when the oil...
Truck runs great until I get around 2,000 rims, then it starts missing and cutting out until I get below 2000 rpms
Hi there. The fuel filter could be plugged up causing the demand for fuel flow to drop making the engine starve for fuel when running at a higher speed. Check the fuel pressure on the fuel rain and run the...
Mechanics replaced water pump but did not replace the thermostat. Engine overheated and blew the head gasket? 2010 Jeep Compass
Hello - this is a judgement call. It is common practice, but not a "standard", to replace the thermostat when replacing the water pump. This is mainly due to access to both easily when replacing either one, and the relatively...
2011 Buick regal makes ticking noise that increase in frequency with throttle but after sometime it dies off and starts again when
Hi there. What you are describing is common with oil distribution or lubrication issues on top of the cylinder heads in most cases. It can also be an indication of loose cylinder head hardware, such as valve lifters that are...
04 Nissan altima knocking and dripping oil
This doesn't sound good. If the engine is loosing oil that fast there is a serious problem. If you have driven the car while it was very low on oil, the damage will be greater still. The engine has to...
Browse other content
Estimates
Services
Cities
I have a 2008 Tacoma, 4WD. I was told today by a mechanic that my carrier bearing is degrading. Said that I had to replace the entire drive shaft, not just the bearing. I am researching and finding that the bearing can indeed be r...
I have a 2008 Tacoma, 4WD. I was told today by a mechanic that my carrier bearing is degrading. Said that I had to replace the entire drive shaft, not just the bearing. I am researching and finding that the bearing can indeed be replaced, without replacing the drive line. Thoughts? Mechanic's Assistant: Are you fixing your Tacoma yourself? What have you tried so far? I will be fixing it myself. I have not done anything at this point. Just trying to get the facts.