Q: There is a loud clunking from front wheel.
Four days ago a clunking started from my wheel in the front. I have recently replaced just about everything in that area so I do not know what is causing it.
My car has 76000 miles.
My car has an automatic transmission.
Noise from the wheel may be a wheel bearing or brake issue and would need to be heard to isolate the problem for you. I would recommend getting a mechanic like one from YourMechanic to diagnose the noise to see if it is a drivetrain or brake issue.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
How do I use the cargo net?
The cargo net can be used to secure cargo in the trunk. To use the cargo net, attach the loops on the net to the hooks in the trunk.
Engine hesitates for 2-3 seconds before moving when accelerating from a stopped position.
The first thing that came to my mind was the Mass Airflow sensor, or MAF. This sensor is located in between the air filter box and the intake manifold. It is the primary sensor input for the amount of fuel...
transmission fluid bubbles over the dipstick any help?
This is caused if air is introduced to the fluid. For example, air can get into the filter inside the transmission pan or may be introduced if the fluid is too low or too full. If you just had it...
Car shut off and back on, ESP light on
Not sure if the ESP system is related to stalling issue but the stability control system is reliant on several sensors for proper operation. It could be the brake light switch (https://www.yourmechanic.com/services/brake-light-switch-replacement), which is a common failure along with the...
Stalls when hit gas
This sounds like it could possibly be a fuel-related problem for your 1991 Nissan Pickup. I would want to know what the fuel pressure is by testing with a gauge. I also recommend doing a compression test to verify good...
Engine overheats, heater blows out cold air, coolant boils in radiator
Sounds like multiple problems here. I would first correct the "no heater" scenario. This is likely the heater control valve (https://www.yourmechanic.com/services/heater-control-valve-replacement) not allowing what is clearly hot water into the heater core. The reason for correcting this first is that...
My truck wont blow either heat or cold air?
Assuming you are referring to the blower motor resistor being replaced, this is the unit that controls the speed of the blower motor (i.e. low, medium and high speeds). The blower motor relay (https://www.yourmechanic.com/services/blower-motor-relay-replacement) is a separate unit that directs...
I drive a 2005 Toyota Prius The park button stopped working. What's wrong
Hi there. One of the common problems that comes up on these newer push button style transmission selectors is that the buttons themselves can break, or an electrical fuse or connection from the button to the transmission control module becomes...
I got a diagnostics back from firestone as I went to get my oil change. I was told the belts were soaked with oil from an oil leak
Hello, thank you for writing in. The belts are designed to be clean, dry, and tight. There are no products or aftermarket sealers that will keep the oil from negatively impacting the drive belt. With that being said, you may...
Related articles
A Buyer’s Guide to the 2012 Nissan Altima
While While it may not be quite as modern and sporty looking as some other models, the 2012 Nissan Altima is still a huge contender in the mid-size sedan category. With both four- and six-cylinder options and a CVT (continuously...
A Buyer’s Guide to the 2012 Nissan Rogue
While While the Honda CR-V and the Toyota RAV4 generally get the most attention in the crossover utility vehicle (CUV) class, buyers should take a look at the 2012 Nissan Rogue. The second-smallest model in Nissan’s line of SUVs and...
Symptoms of a Bad or Failing Sliding Motor Door Assembly
Common signs include sliding doors not opening, noise coming from the door, and metal-to-metal grinding when opening and closing the door.
Browse other content
Estimates
Cities
Maintenance