When I reverse my van it stops moving and making cracking...
Customer
When I reverse my van it stops moving and making cracking noise then I try to go forward and it is hard to move when you turn the steering wheel to turn a corner too sharp it starts making the same noise
Mechanic's Assistant:<...
When I reverse my van it stops moving and making cracking noise then I try to go forward and it is hard to move when you turn the steering wheel to turn a corner too sharp it starts making the same noise
Mechanic's Assistant: Do you have power steering? Have you checked the power steering fluid?
Yes
Mechanic's Assistant: What is the make/model/year of your car?
Saturn 2005
Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far?
I had to replace the front brakes
Read More
Responses
Kurt Mulling
347 days ago
Automotive Expert
Hi my name is \*\*\*\*\* \*\*\*\*\* I'll try to help you with this issue, the website may ask if you want a call, but that is up to you. So was this thing going on before the pads were replaced or after.?
Customer
347 days ago
AfterJust textI think one of the rotars were broke on the corner
Kurt Mulling
347 days ago
Automotive Expert
texting is ok, so you may need to see if the pads are in correctly. if it something that happened right after they were done and check to see if all of the bolts are on and tight. It could also could be a wheel bearing going bad and you did not see it yet.
Customer
347 days ago
Where are the wheel bearingsSome nuts that goes to the bearings where loose when I changed the brakes I tightened everything up when it all was tight it started making noise and troubleAre the wheel bearings the same on both sides
Kurt Mulling
347 days ago
Automotive Expert
I need to know more about the car, like it's a 2005, Saturn what and is it\*\*\*\*\* and what engine does it have so I can look up more info
Customer
347 days ago
RELAY 3.5 LITERS
Kurt Mulling
347 days ago
Automotive Expert
Here is the procedure for those wheel bearings.
Customer
347 days ago
Does the racket pinion come with the bracket right hand side next to the boot
Kurt Mulling
347 days ago
Automotive Expert
If you are meaning the outer tie rod yes it does, and you should not have to take it loose.
Customer
347 days ago
The bracket with bushings is broke on the right hand side or cracked all the way thru. Do they sell that part separately or do you have to buy the whole thing and where you could find that part to buy
Kurt Mulling
347 days ago
Automotive Expert
I am not sure of which bracket your talking about can you send a Pic.
Customer
347 days ago
I tried to send pictures but it is blocked or you wouldn't accept themRacket pinion right hand side next to boot the bracket
Kurt Mulling
347 days ago
Automotive Expert
ok I'll try to find a pic.
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
In the Uplevel Message Center, there is a feature called Gauge mode. Gauge mode helpfully shows some of your vehicle's stats as a graphic. To view the options in Gauge mode. Use the Up or Down arrow keys on your...
On an electronic four wheel drive system such as this one there are a few different things that may trigger a four wheel drive light. A faulty solenoid or motor on the transfer case, an inoperative front differential actuator, or...
I believe the part you might be referring to is not the ignition switch but rather the lock cylinder. The ignition switch as an actual electronic switch located further down the steering column on your vehicle. The lock cylinder is...
If you have already replaced the bulb, the problem may be with the wiring, or with the headlamp control module that your particular vehicle has. You will need to find a VW qualified technician to inspect and get headlamp working...
Hello there, 8800 is a very high idle. Most vehicles max out at between 6000-7000 RPM. If the vehicle idles at 800 RPM, then this would be considered normal in most cases, unless the idle fluctuates unusually. If the AC...
Hi there. It sounds like you need a new ignition switch. This is the most common failure on your vehicle that will cause this. It can also be a failure in the body control module, but that is not nearly...
First check the fluid level in the clutch master cylinder to see if it is getting low. If it is low on fluid then you have a slave cylinder leaking. If the fluid does not go low then you do...
Hi there. There seems to be something wrong with the Hybrid transmission on your vehicle. The transmission may have an internal part that is malfunctioning. I recommend seeking out a professional, such as one from Your Mechanic, to help you...
Hi there. There are some times when an electrical glitch or error code is stored in the ECU that will trigger "odd" electrical problems like you've listed in your question. The best way to determine why this is happening is...
When I reverse my van it stops moving and making cracking noise then I try to go forward and it is hard to move when you turn the steering wheel to turn a corner too sharp it starts making the same noise Mechanic's Assistant:<...
When I reverse my van it stops moving and making cracking noise then I try to go forward and it is hard to move when you turn the steering wheel to turn a corner too sharp it starts making the same noise Mechanic's Assistant: Do you have power steering? Have you checked the power steering fluid? Yes Mechanic's Assistant: What is the make/model/year of your car? Saturn 2005 Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far? I had to replace the front brakes