Q: replace wheel hub bearing on Subaru Outback

It sounds like you may have a bad starter (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-starter). Some times starters will go bad intermittently. This is often due to a loose connection of some sort that causes the voltage to be lost in the path from the...

Hello. This delay is common in what is known as drive by wire engines. This means that the throttle is controlled by sensors and an electric motor. Most of the time when there is a delay that is this serious,...

Hello. It sounds like you are continuing to have a voltage issue. I would start by having the battery cable connections inspected. If the battery or body connections are loose, then this will occur. If they are fine, then the...

The catalytic converter (https://www.yourmechanic.com/services/catalytic-converter-replacement) may be getting overheated and turning cherry red, causing the hot floor and burning smell. The engine may be running too rich which can cause this problem as well. Also, towing the trailer can overheat the...

Each of these codes are for different components and since you swapped the motor with a different size motor than what the car had may be a big problem. You would need to have each code diagnosed (https://www.yourmechanic.com/services/warning-light-is-on-inspection) separately to...

Usually engine vibration is due to a misfiring cylinder (https://www.yourmechanic.com/services/engine-is-misfiring-inspection), and a Check Engine Light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) will be usually be triggered. It may be possible that the vibration is caused by a low idle speed and by turning on the...

Hello. I believe the circumstance you are experiencing is from a worn component in the rear end, such as a bad wheel bearing (https://www.yourmechanic.com/services/wheel-bearings-replacement) or axle (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement). I suggest that you have the rear end of the truck evaluated by...

The front brake pads (https://www.yourmechanic.com/services/brake-pads-replacement) are changed no different that the 2012 version. You remove the caliper and push back the piston and then lube slides for calipers and install new pads. Recommend rotor replacement or resurface (https://www.yourmechanic.com/services/brake-system-inspection) anytime new...

Hello. P0455 (https://www.yourmechanic.com/article/p0455-obd-ii-trouble-code-system-gross-leak-evaporative-emission-by-john-nelson) is the trouble code for a large leak detected by the evaporative emissions control system. The computer will set off this code if it detects a large leak in the evaporative emissions (EVAP) system. The EVAP emissions...