Hi Roy i changed the Relay and it stalled again ,dow i ha...


Hi Roy i changed the Relay and it stalled again ,dow i have to change the cam sensers befor it dos not stall ...

Hi Roy i changed the Relay and it stalled again ,dow i have to change the cam sensers befor it dos not stall

Automotive Expert
Hi welcome back I am away from my PC right now the cam sensors are at the back fo your cylinder heads both side on the v 6 engine. Let me know Thanks RoyIf the ECM really did not fix it I would do the cam sensors next just make sure use factory parts from NissanPost back if you have any questions Thank you

Ok thank you
Automotive Expert
Okay good luck and if you need anything just post back here Thank you!
Automotive Expert
If you still have issues and stalling with no codes stored you might need to replace the IPDM-ER controller

Still not sure what you need?

Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.

What others are asking

Thermostat did not fix overheating problem
The cooling system is designed to keep the engine at the proper operating temperature. If any component in this system fails, overeating may result. This could be anything from a stuck closed thermostat to a leaking radiator. Overheating can cause...
Horn not working
If the fuse is good, the only other things it could be is the button (in the steering wheel) or the horn itself. I saw an issue like this before on the same vehicle you have, the wire to the...
rough running since last service with the following p codes
The first code, P0354 is for a coil primary circuit failure. May be a bad coil. Codes P0304 and P0308 are misfire codes for cylinder number 4 and 8. May be the coil issue causing it. The code P2310 and...
Changing transmission fluid on a Honda
If the transmission fluid is dirty (https://www.yourmechanic.com/article/how-often-do-i-need-to-replace-the-transmission-fluid), you can go ahead and try that. Hondas don't have real filters installed in them so you're not changing the filter, you're just changing fluid. However, whatever you do, only use Honda transmission...
I/M monitors incomplete
Hey there. The two monitors not complete let you know that the computer is unable to complete the tests on both of these systems due to problems with the systems. The first thing to have done is to have the...
Broken engine mounts due to lifting the car
I am not aware of any type of motor vehicle lift, or accepted (i.e., standard, manufacturer permitted) lift practice, that would damage the mounts that hold the engine and/or transmission to the vehicle frame. Of note, if the shop is...
Where is the fuel pump cut off switch?
The fuel pump cut off switch is located behind the lower passenger scuff panel under the dash by the A-pillar. If you need further assistance with fuel cut off switch (https://www.yourmechanic.com/services/fuel-pump-shut-off-switch-replacement), then seek out a professional, such as one from...
Driving below 30 mph, front wheels seem to wobble. New tires and rotated balanced.
You should have the front wheel bearings in the hubs checked for any looseness. This can cause wheel wobble. Also if the front axles are binding can cause the wobble.