Have a 1994 Chev Suburban 350. TBI flooding, changed out ...


Have a 1994 Chev Suburban 350. TBI flooding, changed out MAP sensor, pressure regulator, EGR valve, temp sensor, thermostat. still floods Mechanic's Assistant: Have you checked the connectors on the sensor itself? It's imp...

Have a 1994 Chev Suburban 350. TBI flooding, changed out MAP sensor, pressure regulator, EGR valve, temp sensor, thermostat. still floods Mechanic's Assistant: Have you checked the connectors on the sensor itself? It's important that they not be loose or corroded. Those looked ok Mechanic's Assistant: What is the make/model of your '94 car? 1994 Chev Suburban Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far? Fixing ourself. changed out MAP sensor, temp sensor, EGR valve, fuel pressure regulator, thermostat Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? We did chan ge out the tranny a couple weeks before the flooding started.

Automotive Expert
Hello and thank you for using Just Answer. We are here to help you solve your issues and we may ask questions to you to help us understand the issue Good morning Do you mean the injectors are constantly spraying fuel? If you disconnect the injectors, do they still spray fuel. Roy

we changed the injectors also, they constantly spray fuel
Automotive Expert
OK, even with the connectors disconnected? Roy

didn't try that
Automotive Expert
If they stop spraying, then either you have a harness issue from the injectors to the ECM or it is the ECM itself that is bad. Roy

disconnect both injectors and they should NOT stop spraying ?
Automotive Expert
They should not spray at all. Roy

ok, that's what I thought you meant. we'll try that. we've changed everything else, thats all thats left to do. thanks
Automotive Expert
You are welcome Roy

What others are asking

Gear shift lever sticking in park
You have a shift lock problem with your car. Most of the time, this is caused by the shift interlock solenoid is failing, but I have also seen the shifter assembly break internally and cause it to bind. I typically...
Grinding noise, ABS light comes on
Without being able to hear the noise, it will be difficult to make an accurate determination. But based on the conditions that the noise develops, it seems to occur where a rotating component is contacting a stationary component when the...
Jumped timing
Typically when the word jumped time is used, this means the timing belt (https://www.yourmechanic.com/services/timing-belt-replacement) is the issue. According to my information system, this motor is an interference motor. Which means when the belt breaks, it damages the pistons and valves....
On a good day car starts very easily in the morning or if rested for about 30 mins. However, it does not start when warm
Hey there. This is a common sign of a faulty ignition coil (https://www.yourmechanic.com/services/ignition-coil-replacement). Ignition coils are coated with a varnish-like insulation that becomes brittle over time after being stretched then contracted as the copper beneath them expands and contracts faster...
Camshaft sensor leaks oil 2008 Chevrolet Colorado
Hi there - not entirely sure what your question is. The cam position sensor, while getting oil splashed on the sensor tip, has an o-ring on it to seal against oil leaks. It doesn't not normally leak oil if the...
fuel filter
Hello. We will be happy to assist you. There are are a few things that I recommend a technician inspect. Fuel should have been inside the filter once you removed it. A test must be done to see if the...
1999 BMW 323i wont go in reverse it will drive but just not back up. Sometimes when run awhile it tries to go back when put in rev
The first order of business will be to read the stored codes in the transmission controller. A generic scan tool like the use at the auto parts stores and tire shops will not do the trick in this case. It...
Engine Power Reduced
Hi Chloe. Thank you for taking time to contact us today. It looks as if your Saturn is having a few non-related issues. First off, in regards to the engine problem, it's likely that you have an EVAP system component...
I have a 2001 Nissan Maxima wich I recently fixed from a clogged catalytic converter and when I have it in park and rev it makes a
If your old catalyst came apart it may have broke apart and pieces of it got into the muffler or exhaust pipe and can continue to rattle. You may have to tap on the entire exhaust to locate where it...