I need my lower [control arms](/topics-control-arm/) repl...
Responses
Mechanic01
212 days ago
Hello and thank you for using JustAnswer. My name is \*\*\*\*\* \*\*\*\*\* I will do my best to assist you.. I help many customers, so sometimes my replies are delayed, I will respond once available. During this conversation you will be given an automated offer for a phone call. You may accept or decline that offer.I don’t personally offer this service so if you take this another tech may call.
I see your having some front end issues with the vehicle, what questions did you have about that?
Customer
212 days ago
How can you tell which is needing to be replaced lug nuts or wheel bearings
Mechanic01
212 days ago
you would need to check play in the bearing and rotate and scope it for noise, usually lug nuts if needing replacement will show wear on the threads
Customer
212 days ago
My tire sounds like it's screaming
Mechanic01
212 days ago
that sounds like you have some more damage that has not been fixed yet, you would need to take this to a garage and have them assess the entire front end for damage.
Customer
212 days ago
I'm getting a front end alignment and lower control as replaced
Mechanic01
212 days ago
thats great they should be able to see anything else if there are more issues
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
Speedometer not working in a 2006 Chrysler Pacifica
The speedometer gets the vehicle's speed from the transmission. There are two speed sensors used to control shifting. Input speed and output speed. The output speed sensor is used for the speedometer. If it malfunctions, it will store a trouble...
Accidentally put engine oil in coolant reservoir
The coolant reservoir on your particular vehicle is a part of the pressurized system. In this case, the oil that was in the cooling system can cause a few different problems. When oil and coolant mix, they turn into a...
blower motor only works sometimes
You may have a blower motor that has "dead spots" when it's winding. Sometimes you can tap on the motor if it doesn't start to move again. I would try performing this simple tap test and if it starts to...
The transmission will not shift out of 1st gear. The engine code reads TCM malfuction & P2714 Control solenoid stuck
Chevrolet released a Technical Service Bulletin about this issue in 2013. TSB Number:PI-1131. It suggests code P2714 may be caused by a stuck or non-functioning pressure control solenoid. If you've eliminated that as the cause and replaced the TCM, then...
can a heater core prevent, air conditioning, from blowing cold?
The heater core will not cause the A/C to not blow cold. If your A/C is working properly with the correct amount of refrigerant, then you may have a temperature blend door not working and staying on heat mode. If...
I was sitting in the drive thru when all of a sudden my ABS Light came on. It was flashing. I put my car in park and took it off
The ABS light can come on for a number of reasons, most likely having nothing to do with the vehicle being in park or drive. The ABS system relies on a number of sensors including wheel speed sensors, vehicle speed...
How do you remove and replace a power antenna unit (AC Delco #10285495) on a 1999 C5 corvette convertible?
Hi there. When it comes to removing and replacing the antenna in your Corvette, the wheel well and tire assembly must come off to get the antenna out. You can remove the tail light and get to the antenna mounting...
Lose rpm and hard to start. I have a code p0336 that is read on a scanner.
Hi there. The code for P0336 (https://www.yourmechanic.com/article/p0336-obd-ii-trouble-code-crankshaft-position-sensor-a-circuit-range-performance-by-jamahl-walker) is referring to the crankshaft position sensor loosing a signal to the computer. I recommend replacing the crankshaft position sensor and it should fix all of your problems. If you need further assistance...
No reverse, all other gears work. 2000 Chevrolet Blazer
Hello - I suspect the reverse input drum/clutch has failed in some fashion. This is a common failure on high-mileage 4L60E transmissions as you have. I would recommend having your transmission inspected by a reputable transmission shop for further diagnosis....
Browse other content
Maintenance
Cities
I need my lower [control arms](/topics-control-arm/) replaced with a front end alignment. Both front tires blew I replaced with used good tires and now it sounds like my tire screaming and my lug nuts keep coming loose Mecha...
I need my lower [control arms](/topics-control-arm/) replaced with a front end alignment. Both front tires blew I replaced with used good tires and now it sounds like my tire screaming and my lug nuts keep coming loose Mechanic's Assistant: How old are the tires? And have they been a problem in the past? Fairly new and no this happened after I replaced the tires Mechanic's Assistant: What is the make/model/year of your car? 2011 chevy hhr Mechanic's Assistant: Are you fixing your HHR yourself? What have you tried so far? I want to I had some one tell it's the lug nuts and they keep coming loose like my tire was about to come off