I'm trying to locate a valet switch for a 2008 Hyundai Sa...


I'm trying to locate a valet switch for a 2008 Hyundai Santa fe Mechanic's Assistant: Okay, I'll connect you to the Mechanic to help find that for your Hyundai Santa Fe. Before I do, is there anything else you want him to ...

I'm trying to locate a valet switch for a 2008 Hyundai Santa fe Mechanic's Assistant: Okay, I'll connect you to the Mechanic to help find that for your Hyundai Santa Fe. Before I do, is there anything else you want him to know? No that's it

Automotive Expert
**Bradley Jordan** **Nissan, Subaru, and Infiniti Master Technician** **ASE Master Tech All Makes** **Let me take a moment to review your request.** **_You may be prompted for a phone call, this optional as the request is automatic._** Which system are you looking for a valet switch for?

2008 Hyundai Santa fe
Automotive Expert
which system, like the rear hatch, alarm, etc.

I think the alarm
Automotive Expert
If it has a factory alarm it does not have a valet switch, the remote or door lock key cylinder shuts the alarm off.

It is a factory,
Automotive Expert
It does not have a valet switch.

OK thank you
Automotive Expert
you are welcome. **If you need more help, just follow up with your question and I can give you more information.** **it was my pleasure to help you today, exceptional service is my goal and I hope I provided** **Exceptional service for you today. Good luck with your repairs and have a wonderful day**

What others are asking

Car jerking at high temperatures
A lot of people have a misconception about traction control. Traction control is not a system of its own, it has no module no parts no wires. It is actually an agreement if you will between different systems on your...
Car won't start after removing sysLOCATE device
The SysLocate GPS system was designed to track the location and the speed of the vehicle it was installed in. If the device's power supply was being pulled from the wrong power source or if it wasn't uninstalled correctly, this...
Goes in gear but goes no where. Bleed the clutch
This sounds like you have a bad clutch or transmission input shaft is not turning for some reason. You should have the transmission removed to have the transmission and clutch checked to isolate the cause of the no clutch engagement....
The gear shiter is stuck in park I have to manually shift it and the brake lights don't work.
Hi, thanks for writing in. There are several causes for the symptoms you are having. First, if you need to unlock the shifter, there is an override button you can use to unlock it. It will be a small slot...
What does it cost to replace the front end?
The cost of this repair would depend on the exact parts that require replacement. There are multiple parts on the front of the vehicle including suspension parts and brake Parts. Depending on which parts have failed you may need to...
Where do the two coolant lines on bottom of the thermostat run to? On a 96 Geo Tracker.
Hello. In most cases coolant hoses below or near the thermostat will run to either the vehicle's heater core, or function as bypass hoses, and connect to the manifold. If there are any ports on the manifold that are missing...
Tire rubs against inner fender well.
The damage to the lower control arm bent that bad would cause tire to hit fender. You may have also damaged spindle, strut, tie rods. You will also need alignment after repairs are done to make sure it is in...
Does a bad torque converter cause the transmission to not engage into any gear at all?
What you are describing may be a result of a faulty speed sensor, potentially low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a even a faulty transmission control solenoid. As your vehicle travels down the road, the computer analyzes data being sent by...