Q: Goes in gear but goes no where. Bleed the clutch
Goes in gear while car is on even when the clutch is pushed in but it goes no where. Rpms go up on dial.
My car has a manual transmission.
This sounds like you have a bad clutch or transmission input shaft is not turning for some reason. You should have the transmission removed to have the transmission and clutch checked to isolate the cause of the no clutch engagement. Most likely a clutch assembly replacement will repair the condition.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
The emergency brake activates itself, doesn’t feel safe
Talk to your dealer to check if your vehicle qualifies for recall RC-R01-15 to reprogram your transmission and engine control modules. Since your parking brake is electronic, it may be fixed with this recall. The dealer will verify your vehicle...
How do you set the zone on the compass?
If your car is equipped with an electronic compass, you might find that you need to set the zone correctly. This is because magnetic north and true north are not always the same – it depends on where you’re located...
Bad thermostat causing overheating
The vehicle will need to be pressure tested to see if the intake and/or head gaskets are leaking coolant. The thermostat and housing should be checked for leaks. If these checks are okay, then the thermostat should be checked for...
What causes failure to change gears?
Hi there, and thanks for writing in. There are many possible causes of your transmission shifting issue, though it's impossible to tell what's wrong on yours without first inspecting it. It could have a low fluid level, it could have...
Wheel bearing stuck on spindle
Hey there, thank you for asking about your 2006 Chevrolet Uplander. I just happened to have a vehicle with the same issue. The outer bearing went bad and seized to the spindle shaft. The reason it seized was the bearing...
A bunch of warning lights just came on following a minor accident
With the vehicle being involved in an accident, there can be damage to wiring and/ or sensors, particularly if the radiator was impacted in even the slightest. Make sure the coolant level is correct. Even with the level correct, there...
I have white smoke coming out of exhaust and engine running rough.
Hi There, It sounds like you may have a failing cylinder head gasket allowing coolant to leak from the water passages into the cylinders resulting in the coolant being burnt in the combustion chamber with the fuel. If this is...
I have a 1991 Cadillac DeVille running very poorly very bad fuel economy she runs very poorly no power almost almost like it's bac
Hello. From what you are explaining it sounds like you have a fuel system issue. It sounds like you are getting too much fuel. It can be caused by a leaking fuel injector, but most of the time it is...
Car shake when going over small bumps.
The suspension could be loose or have a broken bushing causing the control arms to move around or the shock absorbers are worn and causing the tires to bounce violently at highway speeds. If you need further assistance with your...
Related articles
A Buyer’s Guide to the 2012 Mitsubishi Lancer
If If you’re looking for a compact that delivers a sporty driving experience, the 2012 Mitsubishi Lancer just might be the right car for you. With a variety of models to choose from, including both a hatchback and high-performance option,...
The Best Used Cars to Buy If You Have a Tiny Parking Space
In In many cities parking spaces come at a premium, so you only want to purchase one small space. This small space will end up dictating what vehicle you purchase, so we’ve rounded up some great candidates. Must-haves Arm yourself...
How to Get Mitsubishi Dealership Certified
Mitsubishi dealerships offer automotive technician jobs to mechanics who are ASE certified or have completed the UTI Automotive Technology program.
Browse other content
Cities
Services