Q: How do I extend the seat belt?

asked by on January 13, 2016

How do I extend the seat belt?

If your seat belt is not long enough to safely and properly buckle around you, you will need to get a seat belt extender, which adds eight inches to the seat belt length. To receive a seat belt extender, visit your local dealership.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Should I Have a Car Battery Charger?
A car battery charger is a valuable component of any vehicle emergency kit. They are easy and safe to use if you read the instructions and understand the specifics of the model you own. Keep in mind, though, that these...
What is the anti-lock brake self-test?
The anti-lock braking system (ABS) on your car is designed to conduct a self-test every time you crank the engine. During the test, the ABS light on the dash will turn on, and then should go out after a few...
Sunroof won't close
Hi. The electronic portion of your sunroof includes the sunroof switch, sunroof motor and body control module (BCM). The BCM supplies power to the sunroof motor when the operator pushes the switch. In some cases, a simple reset is all...
Need to replace Accelerator Pedal Position Sensor
The TPS and a scanner to test it is all that you need. The code P0122 (https://www.yourmechanic.com/article/p0122-obd-ii-trouble-code-throttle-pedal-position-sensor-switch-tps-a-circuit-low-input-by-jay-safford) points to the sensor but a through pinpoint test should be done to make sure the sensor is failing before you replace it....
My truck won't rev past 1000 RPM
The mass air flow sensors (https://www.yourmechanic.com/services/mass-airflow-sensor-replacement) are known to go bad on Nissan Titans. The symptoms you are describing point to the MAF not working properly. Check to be sure you have reconnected the new one correctly, proper continuity and...
Do you need to change the rotor when the brake pads needs to be replaced for the front and rear?
Hello. Thanks for writing in about your Mercedes-Benz ML350. It is recommended to replace it if the rotor surface is worn, damaged, or is too thin. Typically I would always recommend replacing the rotors anytime the pads are changed. By...
Engine shudders when not moving, check engine light on - 2003 Toyota Echo 1.5 L 4-cylinder
ANY time a Check Engine Light (https://www.yourmechanic.com/services/check-engine-light-is-on-inspection) comes on, the first thing you need to do is get the computer scanned. Autozone or advance will actually do this for free so you don't have to purchase anything. Shuddering could be...
check engine light is on
Hi there. For the check engine light being on, to start, get a code reader and scan the codes to the computer to have a starting place with diagnosing your engine. The computer can store a lot of codes from...
Has reverse, but no drive after sitting for months and was working before being parked.
A cause of this can be a stuck manual valve in the valve body. You can check to see if the shift linkage actually moves to the drive position when commanded. If it does, there is a hydraulic fault in...

Related articles

A Buyer’s Guide to the 2012 Mazda MX-5 Miata
The The Miata is one of the few cars of the last few decades to become an instant – and enduring – classic. Adored among young and old, male and female alike, the car has maintained popularity as well as...
Is it Safe to Drive With a Misfiring Engine?
Repairing a misfiring engine can be simple or complicated, depending on the reason it is misfiring. The most common causes of engine misfires are:...
Is it Safe to Drive With a Misfiring Cylinder?
An engine misfire can be caused by bad spark plugs or imbalanced air/fuel mixture. Driving with a misfire isn't safe and can damage your engine.