Q: Heat is blowing cold air

asked by on February 18, 2016

When I turn on the heat in my van, it blows cold air. In addition, both charging ports in the front are not working.

Heating AC Inspection $94.99 - $114.99 Get a Quote

The problem is likely from the control assembly. The manufacturer has a technical bulletin that has a new designed part for replacement. I recommend a having mechanic, such one from YourMechanic, inspect your AC system to identify and quote the repairs needed.

The statements expressed above are only for informational purposes and should be independently verified. Please see our terms of service for more details

Get an instant quote for your car

Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing


Experienced Mechanic?

Earn up to $70/hr

What others are asking

Coolant light is on
The coolant temperature sensor may have a malfunction or your engine computer needs to be reprogrammed. The problem may occur when going through temperature extremes. The computer can sometimes read a rapid change of temperature which will turn on the...
Opinion about Tesla
They are fast as lightning cars. I just met a guy who has one, and I was talking to him about the car and we gave it a ride. They are zippy, fast cars but they are pretty expensive. He...
Recommendation and information on seal conditioners and synthetic oils
No, not to my knowledge. The problem with all kinds of sealers and engine oils is that they have all kinds of additives but no one ever tells you what the exact ones are. So you really can't compare. The...
Ticking noise on a 2003 Crown Vic
Figure out where the noise is coming from first. It could be your driveshaft U-joints are going out (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-universal-joint-u-joint). U-joints click when you move them back and forth. It can also be if any of your brakes are really worn...
Rear end grinds when I first take off but then is perfectly fine.
Hello there, thank you for asking about your 2006 Chrysler 300. This could be a variety of things that will require some inspection to determine. This could be what is known as a center support bearing which is a bearing...
Valve lash is good,check rod bearings. Engine taps under load.doesnt tap when in neutral and revving engine. Timing off 1 tooth?
Hello. Check intake vacuum at idle to "guess" as to the status of the timing. If below factory spec., for example if as low as 15 inches or so (vac. gauge reading), you might be off a tooth. Really, the...
I have an open circuit code on the fuel injector on cylinder 3.
Hi there. From the description you have provided, your vehicle has an open circuit code on the #3 fuel injector, is going to require circuit testing. The fuel injector(s) are controlled by the injector driver(s) in the ECM (engine control...
How many litres of oil will new gearbox will contain
Hello. Your Murano will need 10.2 liters of fluid if it is dry. When the gearbox is new it should be empty and need a dry fill. Make sure that you use genuine fluid from Nissan.
Light brown sludge in radiator and no coolant
The radiator having no coolant and oil in the coolant with the smoking out the exhaust is an indication you may have blown a head gasket or possibly the heater core broke and lost coolant then overheated the engine. Check...

Related articles

Can a Bad Sensor Prevent a Car From Starting?
If your car isn't starting or has a hard time starting, a faulty sensor may be to blame. Car sensors monitor data to keep your car running smoothly.
2012 Kia Optima vs. 2012 Nissan Altima: Which One Should I Buy?
Mid-size sedans can be pretty basic, with four doors and simple and straightforward options, decent but not stellar gas mileage, and an uninspired interior. They can also have great design and fight off boredom through sporty suspension and exciting technology...
The Best Used Cars to Buy If You're a General Contractor
If If you're a general contractor, you probably aren’t in the market for a used car. More likely, you’re looking for a pickup truck, because you need to haul equipment and supplies to various job sites. Most contractors will likely...