Q: Fuse keeps blowing.

This issue may be caused by a couple of different things. A gasket near the transmission filter where it mounts to the valve body could be leaking causing the hydraulics within the transmission not to engage second gear properly. On...

The problem could be with the convertible top module, hydraulic system, cables or latches. The diagnostic procedure for your top says to start by checking for diagnostic trouble codes (DTCs) in the convertible top module. Then, the convertible top limit...

Hey there: Anytime you remove cylinder heads, intake manifold or disconnect the fuel system, it's important to clear any OBD-II error codes that may have been triggered either prior to the removal or after you started the vehicle. The issue...

This may be a variety of potential issues. I would start by checking the oil (https://www.yourmechanic.com/services/change-oil-and-filter) to see if there are traces of water in it. Also, check the water to see if you find any trace of oil it...

Hello - your symptoms suggest that the throttle position sensor has failed. This would not be unusual for a vehicle with your extended mileage. I would recommend having a Car Hesitates during Acceleration Inspection (https://www.yourmechanic.com/services/engine-hesitates-during-acceleration-inspection) completed by a mobile, professional...

Hello - unfortunately, there is only one solution for this problem. Go to your Chrysler dealer, with proof of ownership, and your VIN (https://www.yourmechanic.com/article/what-is-a-vin-where-can-i-find-it) number, and write them a check. The dealer is the only source of electronic keys and...

Hello, thank you for writing in. There are several other components, some that you have mentioned, that can cause a multiple cylinder misfire. With that being said, the fuel filter should ALWAYS be replaced when replacing the fuel pump. Start...

Typically if the unit is functioning and the wiring harness is solid, the sound should come from the speakers without any customization or reloading any software. If you didn't replace the original wiring harness, this is likely the source of...

Hello, and thank you for writing in. The vehicle is likely experiencing some issues with control module that communicated between the anti-theft components. Typically when the vehicle is messed with and the anti-theft system goes into action, you will need...