I have a 2013 ford fusion and it keeps stalling and faili...
Responses
Daniel Chaidez
227 days ago
Good Afternoon, my name is \*\*\*\*\* \*\*\*\*\* ill be helping you, so sorry to hear about the issues here on the Fusion. I know how frustrating it can be to deal with issues after the vehicle has had repairs done already. By the way you describe the symptoms i suspect we are dealing with a [transmission](/topics-transmission-ford/) related issue here. If you are having a loss of power but the engine runs and revs fine then the transmission will be what is causing the problems. I would recommend we have the vehicle scanned to see what code has set that powertrain light but i suspect it will point to a transmission problem and with the issues you have and the common issues on these models i suspect it will be a mechanical transmission issue unfortunately.
Customer
227 days ago
Ok, thanks for the insight. I was hoping it would be the sparkplugs actually causing the problems as I know I need those replaced soon as well. Ill head back to the dealership to get the car looked at
Daniel Chaidez
227 days ago
yeah no problem. it may be a better idea to visit a local independent shop that has experience with transmissions, you will get the same or better service for a lot less money.
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
What is the range of the keyless entry remote?
The remote that locks and unlocks the doors can also be used to set off the vehicle’s alarm in the event of an emergency. The remote has a range of around 200 feet, depending on battery strength and line of...
Key won't turn and car won't start.
If the key will not turn in the ignition normally you can try to turn the steering wheel side to side quickly while simultaneously attempting to turn your key and that may sometimes allow the key to turn. If the...
How do I fast-forward or rewind?
Fast-forwarding or rewinding through a track is very easy. Press and hold the SEEK button with the forward-facing arrows to fast-forward, and press and hold the SEEK button with the rearward-facing arrows to rewind. When you release these buttons, the...
Truck making loud gear noise when driving
This type of noise is typical of a bad hub bearing. When you turn left, you put more pressure on the right tire stressing the already bad bearing. This is why the noise seems to get louder. Bad hub bearings...
My air only gets cold while I'm driving. What's going on?
Hi there. One of the most common causes of the symptom you're describing is when you have a bad or failing AC high pressure hose (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-ac-high-pressure-hose). The high pressure hose is designed to increase and decrease AC pressure during different...
Front end and steering wheel shaking - 2013 Infiniti JX35
Hello. It sounds like you have a tire (https://www.yourmechanic.com/article/how-to-check-if-your-tires-are-in-good-condition) or axle (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement) problem. If it is in the brakes, then you may feel it only when the brakes are applied. Have the front end checked to see if you have...
Which GM pick up rear end has posi, disc brakes and will match my 67 measurements?
Hi there. The axle from a 2001 Chevrolet Camaro should fit your 67 GMC. The axle is about the width of your original axle and it has disc brakes with the posi loc traction control in the differential. If you...
Car Won't Start
Hello. From what you describe it would appear that your vehicle is having some sort of malfunction with the security system. It may be possible that the security system is enabled and preventing the vehicle from starting. This may or...
2001 honda civic ex and was driving down the highway and the car went into limp mode.
One of these codes is for a faulted signal from the intake air temperature sensor. Many newer vehicle have this sensor integrated into the mass air flow sensor and this code trips when the sensor offers a vehicle to the...
Browse other content
Cities
Maintenance
I have a 2013 ford fusion and it keeps stalling and failing to drive after being stopped. The [engine](/topics-engine-ford/) is still on but it won't drive or accelerate Mechanic's Assistant: Is the check engine light on? ...
I have a 2013 ford fusion and it keeps stalling and failing to drive after being stopped. The [engine](/topics-engine-ford/) is still on but it won't drive or accelerate Mechanic's Assistant: Is the check engine light on? Does the Ford stall at idle or when driving? The power train fault turns on, not the engine light. It feels more like a chunk than a shake Mechanic's Assistant: Are you fixing your Fusion yourself? What have you tried so far? I've taken it to a dealership to have a valve fixed but the problem persisted. I can't afford more exorbitant fees so id like to fix it myself if able Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? I'm a quick learner when it comes to mechanical things