Q: engine speed not more than 3500 rpm
No fault code only engine speed not more than 3500 rpm
My car has 185000 miles.
My car has an automatic transmission.
Recommended Services
| Camshaft Position Sensor Replacement | $119.59 - $907.58 | Get a Quote |
| Crankshaft Position Sensor Replacement | $120.83 - $900.50 | Get a Quote |
| Check Engine Light is on Inspection | $94.99 - $114.99 | Get a Quote |
Usually when the engine experiences this condition, the issue is related to the [camshaft]https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) or crankshaft position sensor. These sensors monitor the position of the crankshaft and camshaft in order to determine correct fuel and air ratios. If one of these sensors are malfunctioning, the result is that the engine will not exceed a certain RPM. I would recommend having your engine inspected for issues related to these two sensors. Consider YourMechanic for this inspection as a certified technician can come to your home or office to inspect your vehicle for you.
The statements expressed above are only for informational purposes and should be independently verified. Please see our
terms of service
for more details
Get an instant quote for your car
Our certified mechanics come to you ・Backed by 12-month, 12,000-mile guarantee・Fair and transparent pricing
What others are asking
Car pulls to the right after tire rotation and balancing
Hello. Thanks for writing in about your Infiniti EX35. A pull to the right is not normal. If the alignment is in specification, then the frame needs to be checked as it may not be straight. If it is, then...
Trying to locate the fuel pressure regulator??
The fuel pressure regulator is almost always located on the fuel rail. The fuel rail is located on the top of the engine and has the fuel injectors under it. This will be located right around where the intake manifold...
I'm having trouble Installing new driver side (left) CV axle
It's possible that there is some rust or dirt built up in the splines that is preventing the joint from sliding all the way home. If you can purchase a wire brush about the size of a toothbrush, you can...
Lower ball joint
Hi there. When replacing the lower ball joints to your vehicle, you will need to press down on the ball joint to remove it. Before trying to remove the ball joint, check to see if there is a snap ring...
When the engine is started, warning lights show up on the dash for a moment and then go away.
Hello. This is perfectly normal. These lights come on at this time as the computer is testing them. As long as the lights are going off once the vehicle is started then there are not any problems.
Heater only blows cold
Hi There, It sounds like your coolant temp sensor may not be transmitting the proper signal to the computer. The coolant temp sensor helps to control the temperature of the coolant by relaying this to the computer which then causes...
Replacing starter,
If you took the starter main housing bolts out and removed the main housing then you may have damaged brushes inside the starter. I recommend removing the starter and check the brushes for damaged and replace the starter f they...
Engine sounds loud when first started then quiets down. Should I be concerned? 2012 Dodge Ram
Hi there - your symptoms suggest an oil supply or oil deliver issue when the engine is first started. Check the oil level first, then check to see what "weight" oil (https://www.yourmechanic.com/article/what-type-of-oil-should-i-use) (i.e. 10W30) was used for the last oil...
I have Pontiac G6, it shakes when idle. Usually when I drive and stops on signal. I read some code and it shows P0300 and P0301.
The codes P0300 (https://www.yourmechanic.com/article/p0300-obd-ii-trouble-code-random-multiple-cylinder-misfire-detected-by-jamahl-walker) and P0301 (https://www.yourmechanic.com/article/p0301-obd-ii-trouble-code-cylinder-1-misfire-detected-by-jamahl-walker) are coming up for a misfire on cylinder number 1. Check the cylinder for spark, fuel, and air. Check the spark plug (https://www.yourmechanic.com/services/spark-plugs-replacement) and make sure that it is firing. The spark plug...
Related articles
Symptoms of a Bad or Failing Air Cleaner Temperature Sensor
If your car is having trouble starting in the cold, the Check Engine Light comes on, or idle quality is poor, you may need to replace the ACT sensor.
How Long Does a Cylinder Head Temperature Sensor Last?
The The engine’s performance is largely based on temperature measurements performed by the engine control module (ECM), also known as the vehicle’s computer. As the temperature of the engine increases, the resistance decreases which means the voltage drops. The computer...
How to Replace a Coolant Level Sensor
Coolant level sensors are faulty if the coolant level sensor light stays on extensively or the engine overheats without the light coming on.
Browse other content
Services
Cities
Maintenance