Iv got a 07 dodge ram it's not wonting to shift gears I h...


Iv got a 07 dodge ram it's not wonting to shift gears I had the shift solenoid e changed but it's still not working right I'm thinking it could be in the electrical part maybe a short or something I'm not sure what do you think an...

Iv got a 07 dodge ram it's not wonting to shift gears I had the shift solenoid e changed but it's still not working right I'm thinking it could be in the electrical part maybe a short or something I'm not sure what do you think and how can fix Mechanic's Assistant: How old is the transmission? Have you checked the [brake](/topics-brake-dodge/) switch? No I haven't checked it weres it located Mechanic's Assistant: Are you fixing your Ram yourself? What have you tried so far? No I'm no mechanic iv had other people doing it Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? I just like it to be fixed I'm not rich but I need it fixed

Automotive Expert
Good afternoon The shift solenoids are the electrical parts , Did you have it checked for codes ? If you have codes , let me know what they are and i can let you know what it may be. other than the actual transmission the only other electrical part it the transmission control module

Good afternoon
Automotive Expert
I need to run out but i'll be back in about an hour .

if checked the codes they are po770shift solenoid e iv had that changed already.
Automotive Expert
Can you send me your vin number so i can look up the instructions for checking the wiring for this . I'll send it as soon as i get back to a computer .
Automotive Expert
Here are instructions for diagnosing this code including checking the wiring , if you replaced the sensor and the codes is still there , then you have you go through a ll the checks here to figure out what the actual problem is. Let me know i can be of further assistance

What others are asking

How do I return the personalization settings to factory settings?
At any point, you can return all of the personalization in the vehicle to factory settings. This is very easy to accomplish: 1. Turn on the infotainment system. 2. Press the CONFIG button to select the Configuration Settings menu. 3....
I just had the harmonic balancer replaced and now the car is overheating.
Most likely the harmonic balancer is not the reason for why the car is overheating. It is more likely something to do with the cooling fan or a part of the cooling system, such as the thermostat. I recommend having...
Car doesn't run right - 2005 Chevrolet Impala
Hello and thank you for contacting YourMechanic. You will need the check the idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) (IAC). It is located just under the throttle body (https://www.yourmechanic.com/services/throttle-body-replacement) where the throttle plate is. Unplug the harness and check the plug...
My car is making roaring noises every time I accelerate in any of my 5 gears
The noise is going to be in a bearing in the transmission or one of the wheel hubs. You should have the vehicle lifted and then turn each wheel to see if you can hear noise from the transmission or...
the engine is cranking but not starting
Hi there. If your troubles instantly occurred; meaning your were driving just fine, then the engine shut down and no longer starts, it's likely that you damaged an ignition or electrical system component. Although the distributor or cap and internal...
Car misfires then goes to limp mode.
When the vehicle goes into limp mode when the engine misfires, the computer is shutting down the electronics to the transmission to prevent damage to the catalytic converter as the fuel condition is either too lean or too rich. Check...
Hi Patrick, I was told by my machanic when my engine light sparked in that I need a oxegen sensor, and said that it has to be fixe
Oxygen sensors are tested using an automotive scope or oscilloscope. In your circumstance, if there are more than 100,000 miles on the sensor, the sensor output should be verified on a scope. The mechanic should show you the output waveform...
I have a 2008 s550 Mercedes Benz. I'm having a hesitant/vibration in between shifts at a moderate acceleration.
Hello. The most common cause of this is a failure in the drive shaft coupling. The coupling begins to fail and this occurs. I would have this checked by a shop that specializes in this as it can be difficult...
What would cause my SUV start but not run right with a load?
Hi Michael. Thanks for contacting us today. Anytime you add a "load" to an engine by placing it in gear, minor glitches tend to be accelerated. For example, dirty fuel injectors, mass air flow sensor, EGR valve or even a...