Stop signs start Chicken on the stop signs
Responses
Jake
217 days ago
Hi there, my name is Jake.
Sorry your having issues, but thanks for reaching out.
your question is indicating your equinox starts chicken on a stop sign..... as delicious as that sounds I think it was a typo if you could elaborate fo m e.
Customer
217 days ago
I change spark plugs coils all sensors are map sensor MAF sensor and still you know chicken
Jake
217 days ago
sorry, I am not understanding you.
is the engine stalling at stop signs?
Customer
217 days ago
The engine trouble code P0300 random misfire and I changed all those things
Jake
217 days ago
gotcha! this could be the camshaft actuator solenoid or even the timing chain on these engines. Both can cause this code.
Customer
217 days ago
I change both sensors the time solenoid camshaft sensor and song something about that
Jake
217 days ago
do you hear a slight rattle at from the engine? especially at start up?
Customer
217 days ago
No
Jake
217 days ago
Phone call session started
Jake
217 days ago
k, if no noise at all and you don't think it's the timing chain then I would watch fuel trims on the scanner to see if it may be a fuel pump issues.
if you have a scan tool you can do this here.
Ignition ON, engine OFF, command the Fuel Pump Enable ON with a scan tool. Verify the fuel pressure is between 345-690 kPa (50-100 PSI) with the fuel pump running.
Verify that the fuel pressure, after the fuel pump is turned off, decreases to 500-599 kPa (72-87 PSI), and does not decrease more than 34 kPa (5 PSI) in 1 minute from that point.
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
What Are Hose Clamps?
Hose clamps (https://www.yourmechanic.com/article/what-do-hose-clamps-do) are used to firmly attach an engine hose to a connection point. The most common type of hose clamps are flat, metal bands that use a worm screw inside of a buckle. The loose end of the...
Tail lights and dash lights not working.
I have a good idea of what your problem may be. It is common for the ignition switch (https://www.yourmechanic.com/services/ignition-switch-replacement) to go bad in your particular vehicle. This can lead to many different electrical system issues including your complaints of no...
Car only staying started for five seconds
If the powertrain control module (PCM) does not have proper communication with the Sentry Key Remote Entry Module (SKREEM), the PCM will shut off fuel after two seconds of run time. A full key cycle down sequence must be performed...
Whining noise when accelerate and then let go of pedal
The whining is in the CVT transmission and depending on the noise, it may be a normal noise from the transmission. The noise is the transmission CVT belt changing pitch as you drive faster. Sometime the noise will get excessively...
Transmission problems, cannot reverse
Hello. It sounds like the transmission that was rebuilt and installed in your vehicle has failed. Start by having a mechanic take a closer look at the issue. A certified mobile mechanic from YourMechanic can inspect your transmission and shifting...
Starting problems, 1994 BMW 318is
Hello there. No start faults are common issues on older vehicles such as your 1994 BMW 318is. There are a variety of causes for a no start condition. The most likely are the starter (https://www.yourmechanic.com/services/starter-replacement), battery (https://www.yourmechanic.com/services/battery-replacement), ignition switch (https://www.yourmechanic.com/services/ignition-switch-replacement),...
Blower motor not blowing air
Hello, thank you for writing in. You have to replace the resistor because it was likely the cause of the melting wire. You have to replace that wire as well. Often replacement wires are not the same color. As long...
Can I stop rusting without sanding down and painting my car?
Rust on vehicle sheet metal, and the frame, is extremely difficult to stop once it gets a toehold. To "stop" rust already present on steel, every last minute trace of rust must be removed and then the metal has to...
need to find bleed point for coolant on 2001 lexus gs300
Hello, thank you for writing in. There is not a bleeder valve on the cooling system, as the newer models are designed to "self bleed". Your owner's manual can confirm this, and give you more information on how your specific...
Browse other content
Maintenance
Cities
Stop signs start Chicken on the stop signs Mechanic's Assistant: Will the headlights turn on? Is the battery fully charged? Everything works fine just the checking when you do a stop sign Mechanic's Assistant: Wha...
Stop signs start Chicken on the stop signs Mechanic's Assistant: Will the headlights turn on? Is the battery fully charged? Everything works fine just the checking when you do a stop sign Mechanic's Assistant: What is the make/model/year of your car? 2012 Chevy Equinox Mechanic's Assistant: Are you fixing your Equinox yourself? What have you tried so far? I did the tune up spark plugs coils black couple sensors and it's still the same Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? Next set