My 2005 Chevy Silverado 2500hd 4x4 6.6 manual trans won’t...
Responses
AhmedT111
264 days ago
It sounds like a clutch problem. Did you get any warranty when you replaced it?
Customer
264 days ago
a 2 year warranty for partsNot laborCan I just replace the pressure plate?
AhmedT111
264 days ago
You can. Are you doing it yourself?
Customer
264 days ago
sir. Thanks have to because of money. I thought it would be the throw out bearing because of it being so far the the floor for engaging and the amount of pressure it requires to depress the clutchI have to\*
AhmedT111
264 days ago
Hope that fixes the problem.
Customer
264 days ago
Do you think that could be it or just the pressure plate?
AhmedT111
264 days ago
Hello, my name is \*\*\*\*\* \*\*\*\*\* thank you for using just answer. The site will prompt a phone call, but that is not always necessary. If it is necessary later in the conversation, I will propose it. I am sorry you are having this concern, but I will do my best to assist you.
You will need to remove the trans and take a look at what is damaged. Make sure to check the dual mass [flywheel](/topics-flywheel-chevy/), those are known for failure. If the truck sees heavy duty use, I recommend upgrading to a solid flywheel. Hope this helps, thank you.
Kyle S.
A.S.E. certified master auto technician
licensed smog technician, test and repair, L-1 advanced engine performance certified
Certified Volkswagen technician, 2003,2004,2013,2014,2015
Volkswagen and Audi independent 12 years
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
How do you store presets in the XM Radio?
The audio system in your Honda Accord allows you to program preset stations in the AM and FM bands, but also in your XM radio. You can store up to 12 channels using the 6 Preset buttons on your audio...
Car losing water, but I don't see the leak.
Hi and thanks for the question - it is a good one. Modern cooling systems work under different pressures and with so many hoses and auxiliary water pumps it can be hard to find a coolant leak. Factor in that...
2005 Saturn L300 hard to start
Hi. It seems to me that your EGR valve and EVAP need to be replaced. The car is hard to start because the pressure in the system is not correct in order for the engine to run efficiently. I would...
Car won't go
If the vehicle is in drive and it will not move, then it may be a serious transmission failure. This is not uncommon on this vehicle. If the shifter feels a little looser than usual, then most of the time...
Car hesitates on acceleration
Hello. If your Check Engine Light is flashing that usually indicates that there is an engine misfire. Since the light is coming on I would start by scanning the computer for codes. The codes will help me to determine where...
The car starts only with Easy Spray
Hi there. Thanks for writing in about your 2010 Ford Transit Connect. It sounds like there may not be a crank signal occurring at the normal cranking speed. If there is not, then the engine will not start. If adding...
Replaced the 02 sensor on my E46 and cel came on again with p1189 code again
Hi there. The problem with BMW-specific OBD-II codes is that they are unbelievably vague, In this case, the P1189 code indicates a fuel control fault detected from Bank 2 sensor 1. This does not automatically mean the O2 sensor is...
My forester recently threw a p0028 code. Replaced the intake solenoid and oil pressure switch but the idle is still rough.
If you used thicker oil than vehicle specified then this can cause problems with the intake variable valve lift system. If you used the wrong oi then change oil and filter again with the proper viscosity oil. If the correct...
97 Honda Civic won’t shift automatically
Hi Taylor. Thanks for contacting us today. It is possible that your transmission has an inner seal or gasket that has failed or it simply has debris inside the hydraulic lines that needs to be flushed out. However, flushing a...
Browse other content
Services
Estimates
My 2005 Chevy Silverado 2500hd 4x4 6.6 manual trans won’t shift gears while running and will with [engine](/topics-engine-chevy/) off, also the clutch engages at floor which never did before. Very hard to press down. Please help m...
My 2005 Chevy Silverado 2500hd 4x4 6.6 manual trans won’t shift gears while running and will with [engine](/topics-engine-chevy/) off, also the clutch engages at floor which never did before. Very hard to press down. Please help me. Mechanic's Assistant: Has the clutch been slipping? Are you having any trouble shifting? I wasn’t until the other day I went to shift and it reved higher than normal without me pushing the accelerator. And I smelled a burning smell. Mechanic's Assistant: What is the model of your '05 Chevy? Silverado 2500hd Mechanic's Assistant: Are you fixing your vehicle yourself? What have you tried so far? I would like to as money is tight. I have eliminated any fuses, verified the master cylinder and slave are in working order, no leaks of any kind, and the clutch isn’t a year old. Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? No that’s everything.