Thank you for your time and the info needed


Thank you for your time and the info needed ...

Thank you for your time and the info needed

Automotive Expert
my pleasure

What others are asking

Loud humming noise
The bearing or brushes in your alternator are likely going out. You could also have another issue in your belt drive system causing the noise and lack of charging. A visual inspection of the drive system, a stethoscope to listen...
I need to diabke anti theft I changed out steering colum ignition switch looked at all fuses
Anything can be bypassed, but it will take more time and money to bypass the security system than it will to replace it. This is a common request from many customers and I can say that the manufacturers do a...
When I brake it makes a loud grinding noise
Hi, thanks for writing in. This is a sign of bad or warped brake rotors (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-brake-rotor-disc). When brake rotors get hot due to friction and then col down repeatedly, they can develop low spots in them which can cause them...
How do I tell if my power steering is going bad in my 2005 BMW x3?
Hi, thanks for writing in. Unfortunately, it sounds like your steering rack is done for, and needs to be replaced. This appears to be a wide-spread problem with this vehicle, without a recall or customer satisfaction program from BMW. If...
Fuel pump running with car off
Hello. A fuel pump that stays on when the ignition is turned off can be caused by a few things. If you do not believe that the behavior is normal, then it may be possible that the the ignition switch...
When the weather is nice outside, the car start fine. When it is cold, the car refuses to start until I try it several time
Hello, the first step in resolving this problem is to determine if there are any problem codes set by engine management - even if the Check Engine light is not illuminated. Most auto parts supply stores will check this for...
When changing the engine mount, do you have to change out the brackets one at a time?
Hello. If the engine mounts are bad then they need to be replaced. Many times the vehicle will only need one mount if the issue was found early enough. If it was put off for a long time then that...
Truck wont seem to shift into park.
Since the transmission does shift into park with the shifter disconnected, the problem lies elsewhere. Most likely the issue lies in the shift interlock system. It could be a faulty ignition lock cylinder not triggering the interlock system to allow...
VDC, Slip, service and car take a couple seconds to start.
Hi there. Check the master cylinder reservoir and see if the fluid is low. Low fluid in the brake system will cause the slip light to come on with the VCD light. Also, check the condition of the car battery...