My bottom [radiator](/topics-radiator-cadillac/) hose is ...


My bottom [radiator](/topics-radiator-cadillac/) hose is swelling up and my car start running hot new thermostat new radiator Mechanic's Assistant: Have you checked the coolant? Have you noticed any leaking? Yes and I sto...

My bottom [radiator](/topics-radiator-cadillac/) hose is swelling up and my car start running hot new thermostat new radiator Mechanic's Assistant: Have you checked the coolant? Have you noticed any leaking? Yes and I stopped and that's when I noticed that the bottom red head holes were swelling up and it was cold Mechanic's Assistant: What is the make/model/year of your car? 2001 Cadillac sedan DeVille Mechanic's Assistant: Are you fixing your DeVille yourself? What have you tried so far? Yes I'm a mechanic I got symptoms that I know where what it probably is I probably have to change all the hoses I changed the purge I cleaned it out I just didn't change the hose that run till the [heater core](/topics-heater-core-cadillac/) Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? No but thanks

Automotive Expert
Hi there! My name is \*\*\*\*\* \*\*\*\*\* I'll be helping you today. Just a moment while I review your information.
Automotive Expert
There are usually 3 primary causes for a hose to become swollen. The first is too much pressure. If you’ve just replaced your radiator and cap, there’s a chance that it is creating too much pressure in the system (this is sometimes seen with generic caps) but could also be a sign of a blown headgasket on your DeVille. Second, hoses are subject to wear from the inside out. If the interior of the hose has been worn away, it may look fine to a casual observation, but the rubber has become very thin. Sometimes this creates bubbles or blisters, but if the wear is significant, a large portion of the hose can swell.Finally, hoses can become swollen when exposed to very high heats. If your [engine](/topics-engine-cadillac/) has overheated (due to a stuck thermostat, low coolant or for some other reason), it’s possible for superheated coolant to swell the hose.

1/3 I have a 2001 Cadillac sedan DeVille what it does I can drive it all day but if I go over 70 80 direct the top radiator hose be hard but the lower radios2/3 be swallowed and it be cold I've changed the thermostat change the radiator new [water pump](/topics-water-pump-cadillac/) but I haven't changed none of the hoses none of the radiator3/3 hoses heater core hoses
Automotive Expert
I would definitely recommend changing the hoses as soon as possible before moving on.

1/2 Thanks I'll give you a heads up when I finish tomorrow but I know it's something simple there's no blow [head gasket](/topics-head-gasket-cadillac/) run too long to be blown head no all2/2 in the water no antifreeze smell out the tailpipe my only thing I know different when I turn my economy temperature down to like 70 or 80 it get cold
Automotive Expert
Sounds like the hoses to meJust giving you a list of all possibilities as we go. Probably the hoses like you were saying.

Thanks for the Tips
Automotive Expert
No problem and thank you!

What others are asking

Windshield wiper not working in 1999 Dodge Caravan
Hello there! If one wiper works but the other one is being stubborn that allows us to know that the window wiper motor is good. I suspect the problem is in the linkage from the passenger window wiper to the...
Non stop jerking when gas pedal is pressed to floor
Hey there, thanks for writing in about your 1999 Ford Escort. You may have to have the vehicle checked for misfires (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-a-misfiring-engine). You could have a bad coil pack (https://www.yourmechanic.com/services/ignition-coil-replacement) putting out weak spark or the fuel pressure is low....
Service ABS System, Traction Control System and Service Stability System
Hello. These systems are interconnected, since both of them can control individual wheel brake functions when operating. It is likely that one of the speed sensors are failing. To have this verified, have a qualified professional, like one from YourMechanic,...
Misfiring - 2010 Chevrolet Cobalt
A misfire can be caused for several reasons such as bad plugs (which you have fixed), detonation (bad timing), bad ignition coil (https://www.yourmechanic.com/services/ignition-coil-replacement), vacuum leak (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-a-vacuum-leak), faulty fuel injectors (https://www.yourmechanic.com/services/fuel-injector-replacement), low fuel pressure or faulty spark plug wires (https://www.yourmechanic.com/services/ignition-cable-spark-plug-wires-replacement) to...
My upper radiator hose is pinched in and there's no flow to the reservoir bottle
Hello - it is possible that the pinched radiator hose (wrong hose?) is interfering with the engine drawing additional coolant between hot/cold cycles. If it were me, I would drain the coolant - you need to do that to put...
Jerking reaction when accelerating
This may be a sign of a dirty or failing mass air flow sensor. The mass air flow sensor is a unit in the intake system that monitors air intake as it is mixed with fuel prior to being injected...
How much oil goes in a 2014 jaguar 3.0 supercharged? It uses castrol 5w20, we can find that oil at walmart
Hello, thank you for writing in. When changing oil, you must fill the engine to capacity and also take into consideration how much oil the filer is going to hold. Your owner's manual is the best place to find all...
Intermittent loud hissing ( pressure relief?) sound and white smoke from pass side of engine
Hi there. It is quite possible that your radiator cap is damaged or you have a loose AC connection line that is not properly tightened. It would be a good idea to have a professional mechanic complete a smoke coming...
can you mount a 2014 V6 engine for a mustang on a 2015 Mustang without any discrepancy
You should not have too much trouble swapping the 2014 engine into the 2015 as long as it is the same size engine. You may have some different wire harness and intake hoses and connections you would need to swap...