I have a 2012 bmw [328i](/topics-328i/) I only threw 3 co...

Hi, I'm Chad. Welcome to JustAnswer. I'm reviewing your question and I will be posting your reply ASAP.

Sounds good man thank youI've spent too much money already on this car

Thank you for your reply and that information as this does help me better understand the situation. I’m sorry to hear you are having this problem. I know this can be frustrating. Please give me one moment to type out some info for you. I’ll be right back! A live optional phone call will be automatically offered by JustAnswer, you can accept or if you decide to decline we can continue with text until you feel the live call would be better suited to you. I will try to help you on this here These 3 codes should not make it not start So we have another issue, a weak battery caused the security system to trigger on maybe or key fob signal lost ? does the key fob you have still work the power locks? any security signal on the dash? do you have any type of a good bmw scanner or just a code reader? what is the mileage on it now ? did the reset you did like procedure below Master Reset 1-Disconnect Both Battery Cables ,Positive & Negative . 2- Touch Cables With Each Other For 60 Secs ( this will take any residual power in the Harness to Reset the Vehicle Modules ) 3- Wait 30 min 4- Close all doors and trunk 5- Reconnect Battery Positive First 6- Use The Key in The Driver Side Door Lock Cylinder to Lock it & Unlock,IF You have only a Key Fob ,use it to lock and unlock 7- Enter vehicle and Start it . **Please Let Me Know** **Thank You** **Chad Farhat** **ASE Certified Technician**

we did all this and still nothing all we did was replaced the fuel vapor leak detection pump an 2 o2 sensors now the transmission is locked the braking malfunction popped up driving stability message popped all this out of no whereAll this CC ID codes now 24 167 354 672 309 179Cars never had any issues till yesterday after we changed the o2 sensors.

did you recharge the weak battery what does battery reads on your voltmeter when switch is in the on postion and start postion,12 volts and holding ?

Battery is in good shape12 and holding

secuity light on dash , key symbol or none ? all good there key fobs works still ? Does it hold at 12 volts with key in Start postion, you had voltmeter hooked up and watched reading at moment key in start postion ?

All electronics work went from cranking to nothing I'll get one click and done an the fuel pump will not stop primingI thought maybe camshaft sensor cause I did have an oil leak from the oil filter housing gasket but I replaced maybe it finally went out?? We also had the car jacked up to one side quite high an turn the car on to turn the tires does it have a fail safe for a tip over or something?

Does it hold at 12 volts with key in Start postion, you had voltmeter hooked up and watched reading at moment key in start postion ? I will opt out of your question and open it to other epxerts to help you further on it ,please do not reply back to me since it will lock question back to my screen and other experts will not be able to see it to help you further

sounds like a battery or cable issue.. charge the battery and check power and grounds

They are all good

you say no Crank so do you mean the starter in not engaging?

Just one click an doneNo crank

Then the starter has failed i would pull it and bench test it..or slightly tap on it and see if it wakes up