I drive a manual Mazda Atenza 05 and I find my car turns ...
Responses
Chris (aka-Moose)
259 days ago
Howdy from Tennessee, I'm Chris aka Moose. Who am I helping today? I'm glad you've come here to get help. I will do my best to get the answer you are looking for. I help many customers, so sometimes my replies are delayed, I will respond once available. I try to be online at 1-5 pm and 10 pm-5 am every day.
Normally when the engine stalls when coming to a stop, That is to blame on the throttle body not adjusting correctly to maintain airflow into the engine. If it's an electronic throttle body then it may just need to be cleaned. If it's mechanical then it may just need a replacement idle air control valve. It can also be a faulty brake booster vacuum valve causing a vacuum leak or a faulty reading MAF sensor causing an air-fuel adjustment issue.
Thank you for seeking us for help, I hope I provided what was needed. Press reply if you need to follow up. If you liked my answer please let me know so I can mark your question complete. Moose
Chris (aka-Moose)
259 days ago
Checking in with you. Please let me know if you liked my answer, or need more help.
Chris (aka-Moose)
259 days ago
It's been a couple of days since you replied. I am going to mark your question complete for now. Reply as needed.
Customer
259 days ago
Kia Ora Mate,
Apologies for the late reply as I used the wrong email for this service but thank you for your reply I will use this information going in to assist in conversation in regards \*\*\*\*\* \*\*\*\*\*
Kind Regards
Chris (aka-Moose)
259 days ago
Glad to help
Still not sure what you need?
Have a certified mobile mechanic diagnose what's wrong with your car, at your home or office.
Top Questions
Trending Topics
What others are asking
What do the steering wheel radio controls do?
A quick look at the steering wheel in your car will show you there are quite a few different buttons available. They all provide you with a convenient way to interact with different systems in your car without having to...
Rear wheel bearings making noise
Hi. Wheel bearings typically make a rotational growling noise that is proportional to vehicle speed. So, I doubt what you are hearing it the wheel bearing. Doing some research, it looks as though quite a few people have had problems...
Sunroof stuck
While the information provided on the Honda Prelude is a bit limited, my experience with this car leads me to believe that the tilt function on the sunroof has stopped operating correctly. If the sunroof can open and close but...
Reverse doesn't work? Could it be solenoid?
Hi there, thanks for writing in. There is a reverse band that will lock the reverse drum to reverse the rotation of the output shaft. You will need to have the transmission tested to see if the band is being...
Code p1633
This may be cased by a number of things, however the code p1633 indicates the engine control unit (ECU) may be faulty. The battery light generally suggests that you may have a charging system issue which is usually caused by...
Cam shaft position sensor
Hi there. The camshaft position sensors (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) are located on the front of your engine on the top under the engine cover. I usually do a complete inspection before replacing these because there are a number of reasons as to...
No injector pulse but does spark.
Hello There, You are correct in that if the crankshaft position sensor or the pickup coil were bad there would likely not be any spark to the plugs. In relation to your no injector pulse problem, check the wiring harness...
Where would the radiator drain plug be located on my vehicle? 2003 Chevrolet Impala
Hello, the radiator drain plug will be a the bottom edge of the radiator (https://www.yourmechanic.com/article/how-long-does-a-radiator-last), facing the engine (passenger side). If you drain the coolant, be sure to catch it with a pan of some sort, and properly dispose of...
My clutch pedal sucked to the floor just had the clutch replaced two months ago 2000 Ford F350 Super Duty
Hello - your symptoms suggest the clutch hydraulics (https://www.yourmechanic.com/article/how-a-hydraulic-clutch-system-works) or mechanical linkage components have failed completely. The OEM clutch line includes a "quick-connect" fitting that may have come loose or failed, given the recent maintenance. Checking the fluid level, and...
Browse other content
Maintenance
Services
Estimates
I drive a manual Mazda Atenza 05 and I find my car turns off while slowing down and dropping down gear. Is this to do with transmission fluid, oxygen sensor or something else? Just getting some knowledge about it before I take in ...
I drive a manual Mazda Atenza 05 and I find my car turns off while slowing down and dropping down gear. Is this to do with transmission fluid, oxygen sensor or something else? Just getting some knowledge about it before I take in :) Mechanic's Assistant: When was the last time your transmission fluid was checked? Changed? It was serviced 2 months ago so would that be included? Mechanic's Assistant: What year is your Mazda 5? Sorry I meant Mazda Atenza 2005 Mechanic's Assistant: Are you fixing your Mazda 5 yourself? What have you tried so far? We did have an issue when engine light came on, and they said it was Oxygen sensor before I got it serviced. But haven’t tried anything I’m just curious before I take it in again. Mechanic's Assistant: Anything else you want the Mechanic to know before I connect you? No thanks